My son looked through the stack, no 4 doors to be found, only wagons.To bad its not a 4-door.
Sponsored
My son looked through the stack, no 4 doors to be found, only wagons.To bad its not a 4-door.
Window tint, clear bra, powder coated beauty rings, black Bronco badge
Now all that's left are floor mats, license plates, and a hardtop whenever they're available for order!
Would you be able to post a side view of the winch mount?My 2022 Badlands.
Metal-tech 4x4 frame mounted Step Sliders
Metal-tech 4x4 front winch mount
Metal-tech 4x4 rear swing out tire carrier with two fuel cans
Radflo 2.5 Remote Res.
37" Falkan MTs
Some shots of it here on our 21' Cyber School Bus yellow in Moab when we were testing the front and rear bumpers.Would you be able to post a side view of the winch mount?
Here is some more of the winch mount at your request. Sorry everyone else, its not our 22' Cactus Gray!!Would you be able to post a side view of the winch mount?
How do you like your spear stripe decal?In front of the aptly named Big Truck Farm Brewery
Absolutely love it. The matte black plays off all the MIC accents on the Black Diamond perfectly. The install was way easier than my hood black, and the technique Underground Graphics shows on their website worked really well. I screwed up installing the first piece and stretched it out a bit but the company shipped me out a new piece for a fraction of the cost instead of having to buy a whole new kit. I highly recommend it and Underground GraphicsHow do you like your spear stripe decal?
How's the wind noise with this light bar?Finally got my mods completed on my OBX Sasquatch 2.7. 3” Zone Lift, 4Play 20” wheels, 37 Nitto Ridge Grapplers, light bar, bull bar with 13” LED, RGBW rock lights, front and back bumpers with integrated 3” pod lights, winch, exhaust, side steps, added upfitter switches, stubby antenna and color-matched shackles.
I specifically chose this bar by DV8 because it is mounted in a down angle that puts a good portion of the mass below the roof line so the winshield helps break the wind. I have not noticed much, if any change in wind noise. The 37” Ridge Grapplers did add a knobby road sound but I like that. Plus I did my exhaust so that also overpowers the stock wind noise. Super happy with DV8. They’ve been doing Jeeps for a while so I figure they worked out a lot of kinks for the most part. Really happy with the light bar, wheel liners, side steps, front and back bumpers from them. The quality of the powder coat is really nice. It’s parked outside in Florida by the intracoastal with a lot of salt air so time will tell. Even stainless tarnishes here.How's the wind noise with this light bar?