Recent content by Cfield90

I haven’t tried removing it yet, but I did receive the replacement magnet. It does seem to be a bit more powerful. Time will tell….

Definitely agree with you on the badge front, but I dont see how adding grill lights is posing.

Yup...that's the first pic. I noticed it when I went to post...went to dinner, then after pulled the grill and fixed. Subsequent pics are after fixing.

So not 💯 per the book, as the supplied fuse and wire to tap into fuse box wouldn't push down into the fuse location. I think in part based on the second fuse location was occupied by a fuse (see red arrow in 2nd pic). Mabett has a BD, so thinking lux and high pkg is using some fuse locations the...

Yes, you can. Shouldnt be any concerns with draw, which would the only concern, as long as you want them on the same switch. I am debating about wiring to aux switch vs. how Mabett wired...the always on when the truck is on is the concern. I know they're running lights and all.... Seriously...

Ordered

I reached out to IAG and there is possible remedy en route. Supposed to be a stronger magnet and a clip of sorts. When I get it and installed, I’ll report back.

The one pictured below is not the one I was thinking of, but it’s similar. This one is from Baja designs but the lights appear to be designed to be tapped into the reverse lights, but the mounting bracket demonstrates the use case without having to drill into the bumper.

I don’t know, but I thought it was mentioned in this earlier pages of this thread, but looks like you have part of your question answered 🥳

Not 💯 where it terminates or if it makes it all the way to any connectors by the bumper. Everything I’ve seen showed the wire in the wire track under the driver side threshold, but guessing it could also be picked up in the rear driver side for the more door. I can’t recall what thread it was in...

It’s a separate harness, but the other option is to tap into factory wiring. See https://www.bronco6g.com/forum/threads/installing-rear-fog-chase-light-using-factory-switch-harness.46382/

The original 3D printed ones had the spacers; I used the ones from the 3D kit, and most definitely had the same concern you did. @Mabett these plastic spacers would be a good addition the your hook kit. @Kimberley you have a very keen eye 😉

Update on the cup holders and rear passengers: even though they are aware the cup holder can pop off, the teens have unseated it 3xs at this point. It’s mostly on ingress, but if full of cups with liquid, not ideal. Thank goodness for wash out floors and rubber floor mats! @IAG Support and @IAG...

Copy it into new tab in browser and it works.

They're a great fit and so far so good. Have had the top down and windows down on the hwy and they stay put without tape. They work as intended and help with items sliding. Before: After: