Yes, the BRAKE light (on dash was on) and remained on once I started the engine, though the emergency brake was not nor was ever set in the process of hooking or unhooking the tow bar.
Also, I had a notification/alert that said “Check Brake System”.
Update:
Just went out and cranked the Bronco after letting it sit for about 20 minutes and no warning light. No “Check Brake System” warning.
But that is still not ok. Any thoughts on what caused this and the issue at hand? I have been running this RVi Braking system for years with multiple...
So I just performed a test tow of my 2021 Ford Bronco Base. This is an 2.3L automatic. It has 2400 miles.
I followed the neutral tow procedure and everything was fine there. I use the RVI Brake supplemental braking system. I ran an always hot 12 volt outlet under the dash to power the RVi...
I am preparing to tow the Bronco behind my motorhome for the first time time this coming week. On a few occasions I have tested the process of shifting into, and then out of, Neutral Tow mode.
Observations:
- Bronco goes into Neutral Tow just fine, as described in the book.
- Disengagement...
Just wondering if anyone has tried to or figured out a way to modify the console 12V to constant hot?
I need a way to power my supplemental braking system for the bronco when towing behind my motorhome. Jeeps console 12v was an “always hot” source and just “assumed” that the same would hold...
Thanks. It’s been a while since I’ve been on a forum. Have been very active in Harley, RV, and other camping forums in the past. Good to know that that “Use the search feature” response is still vey much alive and well. Always super helpful.
Hopefully I can find the answer to my very specific...
Question, has anyone on the boards done these yet? I would like to install these, I would like to run them off the parking lights, so they illuminate when the parking lights are on. Put isolated from the turn signals.
(I have the Base model so I have the amber”bars”)
Any thoughts? Suggestions?
All,
I am just wondering if there would be any interest out there in trades for my new take-off factory soft top for their hard top? I know there are issues, frustrations, etc with the MIC tops. Wanted to test the waters.