Below is some pics of my install of led lights from Oreily auto on my outer banks. They look and fit great and hope they last. I drilled a small hole in center grille to run my wire through otherwise the light would stick out to far. Simply spliced wire and soldered back together. Ran wire...
Has anyone attempted to install the Raptor type lights on the outer banks grille? I see the photo posted earlier of the round ones which in my opinion doesn't look quite as good.
I have considerable amount of wind noise once I hit 30 mph and think it is coming from seam of two front panels. I have removed panels, cleaned gasket, and lubed with no help. I did not have this noise first few months of ownership and has gotten worse over time. I plan to tape all seems and...
I will admit I had aspirations it would be better and after 3 months of ownership I feel it is a complete waste, and I want my money back on this technology. I have driven F150, Escape, and even the Bronco sport and they performed very well.
I am very pleased with Proclip mount for Bronco. I purchase a fast wireless charger from Amazon and drilled a hole to run wire from console to holder so it would be some what hidden. I also purchased low profile 17mm ball from Tachform (17mm Amps Ball). The steering wheel needs to be pulled...
I would be lying if I didn't say I was disappointed in the top especially when compared to my Jeep Wrangler JL . The Bronco is everything I hoped for except for the top and I definitely did not want a soft top for my everyday driver. Looks like the front and rear sections are 1.0 and center...
I am very thankful to receive my Bronco but my top is far from perfect. Looks like the front and rear sections are 1.0 and center section 2.0. You can clearly see the center section is a different color and is a little smoother.. The back has a primer applied sticker on 8/26. I don't see any...
Congrats wolfman! I think you were on same train as razarback and I and some how received before us. If the guy in California gets his before us I am going to eat my shirt...
I had blend date of 9/8 and sync software updated on 9/13. Tracker still shows in production, however it shows an ETA of 10/19. So at this point I am not sure what to think, but I would like some notice before it just shows up.