Recent content by PoppaPops

Agree with above if you want the lights on any/all time Bronco is on ... i went a little different route and tied my grill lights to the headlights so they are on/off with the headlights Used this adapter ... SPV Harness Parking/Headlight Connector Adapter ... install was pretty straight...

the sleeve hitch ... i believe there are a few on the market, but this one i made with a 6" linear actuator wired to a switch on the dash ... its basically a copy of one i had seen online years and years ago ... i made up a ball mount that hooks onto it just like the back-blade and rake i have

Sold and delivered the wagon that was in our front yard

i went with Corsa single down-turn for my 2.3 ... mostly because there is NO drone https://www.bronco6g.com/forum/threads/recommended-dual-exhaust-cat-back.70850/page-2#post-2655065

Voswitch B800 LED Fog Light Kit https://www.amazon.com/dp/B0CM913GB1?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1 Install was simple, just bolted right in and fit great ... they have worked very good so far ... i wired them with weatherpack connectors ... the yellow lens lights to the...

i put AMP power steps on my Bronco about 2 years ago ... taping the tiny wires was a PITA ... i used tape to make a little gutter for when i dropped the connectors as it took several attempts to get them connected ... the good news is, once done, they are solid and have worked perfect i am not...

I installed one very similar on my Bronco ... it was fine, but i did also get a bash plate ... post here: https://www.bronco6g.com/forum/threads/ford-performance-modular-bumper-availability.127016/#post-2718246

i had the same decision to make when i bought mine ... ultimately, i went OBX sasquatch ... OBX for the interior (being my daily) and sasquatch for the 4.7 gears and lockers

I ended up using the drawer for tools and M2M attic shelf for recovery gear 57mm for the deeper section, 30mm for the shallow sections: https://www.amazon.com/dp/B084Q48JSB?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1 Get several of these as they dull pretty quick making all the cuts...

Yes. If I understand your question correctly. I bought / used the AIG kit for the dash mount and power hook up. Then the Amazon magnetic part to hold and charge (wirelessly) my iPhone. The wire from the AIG kit plugs into the bottom of the Amazon magnetic phone holder. Unfortunately, we are...

i ended up piecing together the IAGMUX kit with this from Amazon ... have had it setup a few months and so far, has worked perfect https://www.amazon.com/dp/B0FQX8CTTX?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_5

Not sure this help, but I ended up going this route ... took a little work to get the bumper aligned nice, but it is all good ... i think they are China clones, or 2nds, not sure ... but it was complete and fit pretty good, with some fiddling as mentioned https://www.ebay.com/itm/335031183608...

It’s been fine. I was worried about rubbing, but I get more noise from the M2M flip down attic shelf then this. Tailgate has been closing with no issues I did have to tighten all the bolts, all of them, on the Broaddict slide out. But its been fine since

Not sure if this helps, but i used one of these adapters to tie my grill letters to the headlights ... they have many different setups ... i cant recall the specific one i used, i THINK it was this one ... but jsut note, my grill letters work with the headlights, not DRL...

apologies, file didnt upload ... trying again . . . .