Recent content by RoverDude

Yes (It should) It has been a while. I forget what the actual difference in entry vs ajar color is Below is from one of my prior post. For the Bronco: Option 1: Easy mode, Text Version (To enable Ambient lighting in menu) Change ambient lighting from Single to Pantone in the APIM module...

see below

If you use forscan did you save your settings beforehand? Motorcraft website is not necessarily going to be accurate in all cases. You say you don't have any faults but you're getting an error message, what is a fault? Does that mean the MIL light's not on? Have you tried to clear or reset the...

Well VP2DZ-15A416-B is for year prior to 2025 for 2025+ you would need VS2DZ-15A416-C it's different module, thus the different values

You would need to provide some more information in order for anyone to help troubleshoot your issue. Some basic information: Exactly what you did. Are there any error codes. Beside the Hitch, what was the model / part number you installed for the tow module? Would need more information...

Much appreciated!

As the title says, does anyone have the pin out information for what I believe is connector C331 specifically for 26+ model years. I do have prior model years. Just looking to see if something changed

You can install it, there is no Vin information in the trm

If you have blind spot /object detection, and you have the the tow module, The system will deactivate blind spot monitoring when the trailer is attached. It would be best to use the settings above for your configuration.

In your case, leave it disabled I believe

You can add those/ try to add them with forscan. Trailer Light check is hit or miss depending on vehicles (meaning you can add it to any the vehicle, it may just spit up an error) Configuration I listed is what is enabled by using FDRS. You're more than free to add try to add in other...

Yes the Part VS2DZ-15A416-C I posted, it is the correct part that is plug and play'ish

This is what you should want or need! VS2DZ-15A416-C

There's no programming for that, that is a four-pin connector only. That does not interface with the Bronco computer, tow module etc. Unclear what your expectations are but they would be correct in what they're offering.

What are they installing specifically part wise? What are your expectations of what's being installed.