Recent content by sevenfab

I’d advise calling them.

Here is the other bumper they plan to sell.

Couple pictures of camera with winch

Intercooler skid is made of 7 gauge steel, boxed and bent on a press brake.

I bet you can use this for ACC: https://www.addictivedesertdesigns.com/products/ford-bronco-2021-2022-adaptive-speed-control-relocation-bracket-in-hammer-black_ac23152501na

I have (had) this on my Raptor and super thankful it’s not on my Bronco.

Sensors incorporated perfectly. I’ll get a pic with camera in a bit, still have great view, usage.

Full side picture

It’s designed for S2 lights to work on the outside but I had S1 on hand that I pulled off my raptor that I liked better with the Squadrons.

I’m trying to get them to do a rear bumper too.

I just went outside thinking someone would ask ;) The hoop does a great job of pulling it together.

Guys at Shrockworks hooked me up with a front bumper. Fit, finish and quality are great. Finally found a good home for my Warn;) They will also offer one with with just a small hoop.

no, it has brackets from Baja Designs that mount to frame.

Got 13k miles on replacement motor. So far so good 😊

My story, happened last November. Lost engine while driving up feeder to hwy. Gullo ford replaced engine within 2.5 weeks but waited another 6 weeks for new 02 sensor. Bronco has a little over 15k miles now. So far so good. Gullo ford was great. Gave me a loaner f150, actually 2 because I was...