Recent content by shansen

I did not need to drill. I removed the bolt on the forward left side of the transmission tunnel and used it to go through the bracket and the spacer. The nylon spacer is 1/4" thick.

Thanks to this current thread and this thread, I was able to install my MXT575 under the center console in a few hours today. Instead of wiring the power to the wire behind the glove compartment, since I was already pulling the antenna cable through the firewall grommet areas, I pulled the power...

Thanks to this current thread and this thread, I was able to install my MXT575 under the center console in a few hours today. Instead of wiring the power to the wire behind the glove compartment, since I was already pulling the antenna cable through the firewall grommet areas, I pulled the...

Payment sent. Thank you.

I believe the one on the far left is running to my light bar. The middle two go to the ARB compressor, and on the far right I have an on-board trickle charger. For the negative terminal, I'd connect on the bolt where the BMS is connected, like below.

Yes, just a small slit, about a quarter of an inch, is all you need to pull the wire through. Make the slit at the base of where the curved rubber hits a more "solid" rubber.

I don't have any pictures of pulling the wire up the pillar; it did feed through pretty easily after fishing a long zip tie through the pillar and then taping the wire to it. Two pictures below, the first shows the Heretic plug; I could not get a good seal on the hard top panel with this plug...

This may help someone at some point. I installed a Heretic light bar using the Heretic harness (Ford wire for light bar is not a heavy enough gauge) and for this install, you run the wires from the engine bay, through the passenger side wire grommet, and then up to the light bar on through the...

My order was on June 30th, order #7824 and arrived Friday, November 3rd (about 18 weeks). I went with the standard height install. Post-machined finish. Very happy!

Local sale pending, I'll update mid-next week if it falls through.

Bronco OEM roof rack from my 2 door Bronco, will fit both 2 door and 4 door Broncos. Does not fit Bronco Sport. This came from the factory and I removed it after about 3500 miles (went with a different setup). Includes all parts to install and the triangle tool from Ford. Located in Orem, Utah...

Hello all, I have a OEM roof rack I've taken off by 2dr Bronco with about 3500 miles on it. This will fit both the 2dr and 4dr models. Listing it here first if your local to UT and looking for an OEM rack, I'll post it in the classifieds later in the week (really don't want to ship it). Great...