Recent content by SkiSquatch

If anyone is building one out, I have an extra set of straps from CustomTieDowns. They worked great, but were a tad too long for my lift/ceiling to get into a loft I have in my garage. So I have an adjustable one now. ~$20 + shipping (I'll proably post in marketplace over the weekend). PM me if...

What's the setting(s) for the fake engine noise? Thanks!

Ordered, Thanks for the update! Neil

Sounds like it works, but the one's they are working will lift more weight. Without a step stool, I don't get enough leverage, so the new one I think may be easier for me. Thanks!!

Any update on these? I'm ready to order when its available! Thanks!

I bought the dual tops when I orderd my 2023. I got it late September, so never intalled it. The box has the windows, still wrapped. $1500 or BO

7/64 bit did the trick. Drilled it from the bottom, and a bit of wiggling got it off. Good idea @jtimon.

I’ll try drilling tomorrow. I have dual tops so it isn’t on the truck yet. The replacement screws go in from underneath, so you may have to remove the top from the truck to get the screws in.

I have the same broken part and ordered the aluminum replacement. anyone know how to remove the old one? Its held in by 2 screws (easy) and two studs. The studs are the painpoint. The new one comes w/ screws instead of the studs.

Do you have a link for the four straps?

I did a $100 used dell with touchscreen from eBay. Dedicated to the bronco. I only have Mac’s as well.

My print installed, Thanks!

Winter is back in NH!

I orded this with my Bronco and decided not to install. Going a different route. $230 OBO including shipping to lower 48 Other States, PM It’s not assembled, so included the Ford picture for clarity. PM if interested.

In those plastic bags are the door and roof bags. The trim panels are in the box above the six screws in @Glade Runner’s second and third pic.