Search results

They told me they were built the same, with the same cutout modification in the side rails, no difference. It’s just for order tracking.

Great post! I saw some of your pics on their IG and FB feed. Looks great with the white on blue and look forward to seeing it with the lift/wheels/tires!

One more: 7) Don’t roll down the windows after a big rain until you make a few turns! The roof collects a LOT of water around the panels and you’ll get a bath! Gutters would have been a nice addition…

Definitely sturdy enough. When putting in the bags I close all the latches so they lay flatter and snag less going in/out.

A quick update since I've had it for about a month: 1) I've had to tighten the latches a few times now. Some areas more than others, else I got a slight squeak. 2) The panels weigh a good bit and can be a bit awkward to handle by yourself given the size, but very doable. 3) I've noticed slightly...

It’s the LOD Destroyer bumper, check out this thread. It’s been pretty solid so far. After a while the rubber stops started to squeak over bumps, but I just added a dab of grease to the surface of them. I also had to add an extra nut to them to lock them down as they would slowly loosen. Still...

Also note, it seems like the top/back edge of the molle won’t fit against oversized aftermarket 6.5” speaker pods. So I started trimming the drivers side… Don’t do this, it’s not needed. The edge will slide right inside between the speaker pod and rollbar without issue… No trimming was done on...

So to work with the @Mountains2Metal Attic Tray pin arms/brackets that mount to the rollbar, Sam suggested using the AD pocket molle’s for the BRaptor that have a cutout for the brace. Theirs do add quite a bit more storage than the cheapies I got off Amazon, and waaaay lighter since these are...

I think you might be in the wrong thread as this is not an OEM top and the design is no way similar? What you mentioned will never work with the Armadillo modular design and the semi-permanent shell.

Agreed, I asked Fabian about it prior via email and he said they could take care of it during installation…no additional $.

I always loved the HPR, was one of my top choices. Looks great!

Did you twist/solder these colors from the harness together before connecting to your sub wires? What size wire did you use to the sub? I listen to everything from rock>country>hiphop>RAP>EDM and has plenty of bass and exceeds expectations for a 10”….always been a fan of JL for the tighter and...

I get tons of bass and mine sounds great, maybe his is blown or wired incorrectly?

I had a soft top and it would get too loud for me with the top up, loud enough with the top down on the hwy. There was no distortion up to lvl 23 volume with their tune. Sounds even better with my Armadillo hard top and normal driving I keep ~10 volume now, never past 15, even with my 37’s in...

💯 I had the same experience, a class act and no trash talk about anyone.

Yeah, thought it was included as well…and maybe it was with mine and I paid them an extra $50 😝 It’s not now though!

Defroster is included, but not the harness. I had to buy it and it’s noted in the description:

Looks good!!

Awesome, post some pics! They used them to mount the TrailRax and attach the rear brackets, but that setup/brackets are still going through testing. Alternatively I’ll use them to mount a rear half rack, which I may need to mod a bit to work (if AD doesn’t come out with their own). I also got...

They did it for me at the time of install, no additional charge. They also had the L-tracks pre-installed.