Search results

Yep, and it’s still holding up great with no rattles aside from all the crap I have hanging from it. @Beach_Bum , it looks like your forum link is malformed. Here’s the link

Yes, my order fulfillment station is the trunk of a 1970 Triumph TR6 project car. Don't judge me. Got a new batch of product back from steel fabrication and powder coating. Both shops indicated that prices are about to go up, but I'm not sure by how much and whether I'll need to pass along...

I've never tried, but I would have to assume that the toplift wouldn't work as the attic tray fills much of the space between the roll bar and the rear of the hard top. There's a video on my product page that might give you more visibility into how/where it sits...

This is the tool roll that I use and it fits great in the cubby, however, there are obvious tradeoffs with respect to how many tools you can get to fit in there. It's a bit of trial and error.

I'm outside of the warranty period so it's out of pocket for me unfortunately.

I’m sitting at the Ford service dept right now and my leak is coming from around the grommet as well. The service advisor just showed me the tank and there’s a crack in the 2 o’clock position and another crack in the 7 o'clock position that you can see once the grommet is removed. The tech is...

I haven't seen any prevalence of this one yet. My 2021 2.3 Badlands AT with 46k miles is in Ford service repairing a transmission fluid leak that the oil change tech noticed. They pulled the transmission and it's a cheap seal, but obviously a ton of labor to repair under warranty. I dropped it...

So much good info in this thread that it's hard to call out anything that hasn't been covered already, but I will add that the gear you decide to pack should ideally be so unobtrusive in your daily driving that you're not inclined to remove it from the vehicle between trips as that's what will...

Unfortunately, I don't have a better solution. The only idea I can think of is to design the rack so that it can pivot down flat against the roll bar. However, adding the necessary hardware for this would increase your costs and could also lead to rattling issues. These are two factors I have a...

Those are two very large adults :) Great product - looking forward to the release. Would be great to have an optional accessory that is essentially a vertical piece that attaches to the top, but on the seat side to keep items from falling into that gap when sliding it out. Would be a bitch to...

Well, yeah, that's why I led with the fact that it's expensive but I found one for cheap. I think it was around $150. I needed a cable and called ARB support, so they sent me a replacement cable that just so happened to come in a box with another full battery, so now I'm running two of them...

It's pretty expensive for what it is, but I was able to pick one of these up for dirt cheap when a local business was closing down. It works surprisingly well, with 18 hours of power, and takes up next to no room as it just attaches via magnets to the side of the fridge. I keep my ARB Zero...

I'm not big on going off-road in groups so I'm frequently solo which means the boards are good insurance and are just another tool in my kit. There's no reason to not have them available, particularly if they're not taking up valuable storage space in your Bronco.

Freshly cut 22 foot tree fit perfectly. Unfortunately, my living room is 16 feet, but c'est la vie.

I have an automatic transmission. I ran my Midland radio power through a driver's side grommet and it was a PITA to get behind the HVAC/center console so I like the idea of running my ARB wiring through the passenger side grommet. So, from there, do you just fish the wire along the removable...

What route are you taking for that? I've been sitting on that wiring kit for too long and need to get in there and run the wires. Any pics of that firewall grommet, or even, where it's located? Regarding the OP, I was speaking to the ARB rep about issues I was having with my ARB Zero fridge...

Took me a minute to find it, but here's my thread on the issue

My '21 had this issue early on and they simply replaced the Transfer Case Module. No issues since.

My MGV vinyl has held up well with the dogs, but I do cringe every time they end up on the seats. I think Carhartt offers 60/40 seat covers however now I pretty much just run with the rear seats folded down permanently so I haven't dug into those. My mini golden doodle loves the console as well...

My 3 years of Connected Navigation expired so I easily used points to renew. I rarely use it but it is nice to have when I’ve have no phone signal for phone navigation