Has any way been figured out to change the set points for the factory Tire Pressure Monitoring System?
A couple "push this button" suggestions were given a couple years ago but none of them will set my pressure alarm to 30 PSI, down from the factory approximately 35 PSI.
I have not found any...
I have read most the Turn Off Road tailgate tire carrier threads that are posted.
Anyone care to make a long/longer term report as to how they hold up? Any issues? Any suggestions before we order one?
I am trying to find the part number for the bolts that attach the hinges to the tailgate.
These are the 4 bolts that you see when viewing the Bronco from the behind.
There are 2 bolts in top hinge and 2 bolts in lower hinge. They have Torx heads.
Can you please tell me the part number?
I think...
November 21 Bronco went into service, 2.7 engine
Like many on this site I have been receiving Ford Pass notices of Battery Saver Mode etc. This has been going on for many months and I never had trouble starting. Some months ago I noticed that my dashboard Voltage reading was always up in the...
I recently found an AT&T Sim Card in my driver side floor board. I was puzzled about it and had no clue about where it came from. Several days ago I remembered we have not received any "Your Bronco is shutting down to save the Battery" type of messages. I looked at my Ford Pass and found we...
With factory Sasquatch rims does the Haltec locking air chuck fit? The rim is tight around the valve stem.
I have trouble with my fat fingers getting the air cap off and on.
Is there a locking air chuck that is easier to use and or better than the Haltech? I see a long skinny $50 chuck on...
Can the front lower control arm be used as a jack point?
How about right under the shock mount?
Wanting to lift a front tire off the ground but not wanting to lift as much as the chassis rail "official" lift point requires.
Do any of you have a rear side window mounting solution for Rotopaks?
I know about the Badass brackets. Are there others?
We don't have a rack and would like a stand alone solution.
We have factory halogen lights and are considering splicing diodes in the line for flat towing.
Is there any one that you know of making a 8 to 12 inch harness that would be plug and play fitting between the factory taillight Molex plug and the factory supply line Molex plug?
This harness would...