You have my condolences. While nobody can really understand how difficult this may be, my family is working through a similar process. We lost our beloved Daly-dog last month after 12 wonderful years. I think of her often and say to my myself “Till Valhalla sweet Daly”.
Good to know thanks. I was aware that Accutune offered tuning options but I thought it was limited to valving. Good to know they can offer coils that fit and make recommendations based on build/weight for replacement coils.
What brand / weight coils did you get?
I’m leaning towards Fox, but I’ll admit I’m biased based on previous experience with Fox.
I’d wager I’ll be the guy needing HD springs for my 2Door.
2.7L, 37’s, Relentless bumper & skid plates, RCI sliders, tailgate reinforcement, GG tailgate table, plus camping gear. She gets heavy. Even with...
Spring cleaning.
2Door RCI rack for sale.
Lyons CO.
Posted to the marketplace.
https://www.bronco6g.com/forum/threads/rci-2door-roof-rack-accessories.90685/
$1200
Edit: Reduced to $1000
Located in Lyons Colorado
Local pick up only.
RCI 2Door Roof rack
- New hardwear pack with fresh rubber fairing seal, adhesive pads & all bolts needed to fully rebuild if desired
RCI Roof rack accessory plates
- three sets (six plates)
Rotopax DLX pack mounts
-...
My 2-door passenger door whistles badly with a cross wind at speed. I have to carry gaffers tape for road trips and tape it closed sometimes.
Two local dealers are clueless, not really interested in helping. Won’t call me back. Etc.
Per my expectation the front suspension sagged about 0.5”. I plan to drive it like this for a bit until I can find time to recruit a friend to help me wire up the winch and some pod lights. Need to start a quarter jar for proper coilovers, he he he.
First bumper side wing took me maybe an hour, then I remembered I actually had the correct swivel socket. Second side took me ten minutes. Ha ha ha….dumbass.
Sat progress. LOD frame brackets, bumper, main skid & drilled holes for the hoop assembly. Tomorrow I’ll install the hoops and winch tray. Not sure where I’m going to mount the front license plate yet, maybe above the fairlead or below the intercooler air duct.
Question about the LOD brackets please. Did you drop the intercooler to make room to drill the holes on the inside of each frame horn? Any tips would be most appreciated. Thanks.
Ok, with some luck I’m finally going to install the bumper, skids and LOD frame brackets tomorrow.
Swept out the garage and took over my wife’s spot so I’ll have some room to play.
I finally had a moment to get under the truck. Looks like I may be one bolt short for the T-case skid, directions...
Here are a few pics of the Kenda’s. I neglected to mention they rule in the snow. I had 10.5” wide 35’s on my Tacoma, admittedly they were better then my current 12.5” wide 37’s but the shorter wheelbase is worth noting.