Search results

I was able to watch it but does say not available. Pretty tippy there, 😆

303 aerospace protectant

You know if these guys got the steel intermediate shaft housing done yet? Didn't see anything on the website.

For $400 this looks to be an ARB knock off kit, you would just need a fuel skid to complete it... https://a.co/d/0b1m21tG

This is the one I got, been great thus far and have probably aired down at least a hundred times by now... https://a.co/d/05gtZqcI

...and if you offroad much, you won't see the scrapes that you will end up getting as easy!

I just torqued them to 60 foot pounds. It's not leaking yet, 😆, we shall see if it does or not...

Good morning Bronco6G! I'm getting ready to put my front diff back together and am looking for the torque specs on the case bolts and the 4 bolts for the intermediate shaft tube to diff. I've searched hi and low and have not found this information as of yet. @Ducati1098 @flip @Brian_B Thanks...

When installing my Adam's Driveshafts I didn’t get the pinion nut tight enough, even though I followed the steps to a tee in the workshop manual. I think the splines were a little tight and that's where I messed up. Anyways, the pinion kissed the diff lock magnet casing and that is where the...

I edited my post, it was Coverking, not Covercraft that I got mine from.

I got some from Coverking that are made to fit the bronco with or without the molle panels backs. https://www.bronco6g.com/forum/threads/seat-covers-that-dont-cover-molle-panels-on-back-of-front-seats.129892/post-2767473

Went out to Dome Plateau...

Can we clone you and put one of your clones at every dealership in the country so all we have to say is, "I'd like to speak to Ducati, please." Then we knew we weren't getting bullshitted and shit would get done right!!! 🤣

Yes, but it may be as simple as changing their 64 to 30 and sending it your way... doesn't hurt to ask. It just plugs into the gateway module.

S&B makes a DTE piggyback device for 23+ Superduty's. Maybe one of you can talk to them and see if they can't help you out on the Bronco bigger tanks.

Is that a newer version of the Tauler Jack?

I just drilled out the door pockets and used nut and bolt. The back of the seats molle panels come out. They snap in and out from what I remember. Here are some pictures that I dug up...

Finally got my driveshafts installed!!!