Search results

Mine was the water pump. Dealer replaced it when they did the drive shaft recall.

Just discovered I’m leaking coolant as well. I have an appointment scheduled for oct 31st. I searched from the top and bottom and can not pinpoint it but it’s right around the seal between the engine and transmission. Not sure if it’s leaking from there or leaking from the top and running down...

I used the upfitter as well. I had the harness that included a rigid switch and I know I eliminated it but I can’t remember exactly how I did it. The upfitters are fused. No real need for 2 fuses on one circuit so I probably plugged in the connector into the light and used a butt connection for...

Fox Ford Traverse City, MI Paid MSRP for Bronco and GT500!

I have had the M-1821-B @Ford Motor Company winch kit installed for a couple months now. While I love the looks and build quality I am running into a few issues with the software part of the install… 1) The front facing sensors have to be toggled on and back off in the drivers feature menu...

Picked up the ford performance winch kit M-1821-B from my dealership. Install went smooth and it looks good. On the last page of the instructions it states to disable the front facing sensors in the Sync menu. After doing this the sensors don’t seem to shut off. I put it in drive and the sensors...

Any ford parts guys out there giving out deals on the M-1821-B winch kit? Looking to use my Ford points towards the purchase. I could pickup in Michigan if shipping is outrageous

Fox Grand Traverse doesn’t charge extras or ADM. Picked mine up June 23rd. Did you get it yet?

Found this message on the Ford Pass app. Over the air update. I haven’t noticed anything different.

I’m guessing I will be near the top of the list. I will keep everyone posted once I get word mine is in.

Been loving mine as well! Going on 3k miles and couldn’t be happier! Sending positive vibes for all still waiting!

I like the look of those

Material list… 2 pulleys: https://www.acehardware.com/departments/hardware/chain-and-rope/pulleys/5308036 a 3/8 50’ “anchor” rope. https://www.amazon.com/dp/B00W12CUFS/ref=cm_sw_r_cp_api_glt_fabc_BJEV0W7WE2S3X8VHC9QW?_encoding=UTF8&psc=1 Husky Carabineer I found at Home Depot...

Yes with 2 people. My wife and I can remove it although it’s a bit awkward. The rope and pulleys do make it easier.

My main use is to lift the top off, move the Bronco and lower the top to ground level. In northern Michigan it’s not likely the top will stay off longer than a day or two.

Do you have a link?

I actually don’t mind the sway, it helps me line up the top to the Bronco. I do worry about the single lag in the ceiling, but from my research a 5/16 lag will hold over 200lbs. I use one hand on the rope and one hand guiding the top in place.

Installed a rope hoist for the rear top. Once rigged up I put a “Taylor” luggage scale on it to measure the weight. I got 69.4 lbs. I rigged up 2 double pulleys and it takes about 17lbs to lift the top. I used 10’ straps and I have a 10’ ceiling. For my rig 9’ (possibly 8’) straps would have...

I’m willing to bet I have more off-road miles than any other consumer 2021 Bronco in existence. Although this clip is pre powder coat.