Search results

Yeah, that looks nice! The LP6's is what i will probably do on the EG.

Nothing that i can hear from my rediciously noisy hard top! The Diode Dynamic lighys seem to be very nice! I still may try some baja designs though one day.

I actually bought the m2m mounts because i liked the location for the front of everglades. The lights were sitting with an outward slant and they too allowed shaky beams and vibrations even on road. I wound up ordering the spv mounts which were an improvement.

Well I do have the TX flag and Dont tread in me flying high on my dock!!!

Local shop. Wrapabull in SC

Added a flag to the EG!

Got creative with rubber plugs from my local Ace.., btw rubber washers pressed in stayed in place until i removed. This pic had 3 different thicknesses to see which one fell out first. None did.

I could see myself doing the vents and a set of mirror caps. Just cant decide if vents would even look good or best painted? I have grown to like my metallic black flairs and now think the painted ones look funny..

Where did you find the aluminum snorkle vent? The plastic sucks!

Wish it was code orange!!

No, used rubber stoppers. Sas wheels were easy, i wrote down everything somewhere. The BRaptor required a little engineering. Thought about making half a dozen sets and selling them.

Made some lug plugs. Looks much better

So my quest to figure out why my 24 Everglades windnoise is so bad from the passenger side rear and overhead I noticed how different the rear doors fit on each side. I will say no noise from driver side. The right rear door just doesnt fit well and it is not even flush. Would this cause wind...

Added black ford logo to rear tailgate. DD 5 inch ambers inbound for this weekend...

Im going w the BA Tents single mount w both sides. Same height as oem and cross bar is now black only

Installed FP Rigid light bar and a set of Mountain2Metal bumper light mounts.

It pops out very easily from inside. Spray a little windex on it from under the hood and it comes out very easily. Also much easier to put back in from inside. Windex or dawnare your friend. Also a drop of dawn on the small slit will make pulling the wire a little easier.

Wondering what folks did with the white wire for backlight option that I understand the FP light does not have programmed into it?? Did you just cut the wire as short as possible? I ran into hood thinking there must be a way to make backlight work. No luck. The 3rd wire under the weather seal is...

All done, several trips to Ace. Ford needs to work on their instructions or lack of...

What is @Ford doing?? These instructions are absolutely worthless. No mention at all of multiple things that would be good to know. Two bolts had to be removed, not a word about. Not a mention about airbag and what your supposed to do with it. Mid trim on door needed to be removed to get the...