Ive had this intercooler for a few months now. Its been good. Fit is great. You do lose the active shutters but motor stays in place so no codes. Install is easy. Most time consuming is bumper removal.
I have noticed cooler temps and quicker recovery/cooling under boost.
For those curious, I...
Has anyone tried the leveling kits from the regular sasquatch on the Hoss 3.0?
I have the zone offroad level kit on my FE. Its just a plate under the lower mount and a plate above the upper. Being the 3.0s will bolt in stock location, it would lead me to believe I could still use it when I...
I know alot of people are, but figured if I don’t ask I wont find.
Looking for a set of takeoff Fox hoss 3.0 shocks from a 4door. As close to Northern California or willing to ship would be cool.
Message me if you’re have or are thinking of upgrading.
Thanks
Yea it sounds like crap with valve closed. Open sounds decent.
Id like to see one with dual tips.
also anyone know if the dc port in the back is powered key off? Wonder about battery drain
Added J&T oil separator, Ford performance hood struts & a resonator to my catback Flowfx to try to take some of the higher vibrations out.
previously installed intercooler, afe intake and afe hot and cold tubes. Ready for that @COBB Tuning stage 2 hopefully soon. 🤞🏻
If it doesn’t say CPe across front and doesn’t modify shutters. Unlikely itll ever be noticed. I’ve swapped my intercooler a couple times with one that removes the shutters.
These are very easy to swap back to stock if noticed. Just gotta store it.
15mins and a 15mm and its swapped.
I have the flowmaster flowfx catback. I love it on my raptor so it was my first choice. Great looking kit. Install easy. Love the sound at cold start and outside. Driving no drone but its loud. Especially 3500k. The broncos have no sound deadening in the cargo area, after a while the plastic...
I got mine installed and works and looks good. I just found that on mine 21 FE that it will either sit down fully into the rubber grommets and not line up the bolt holes or the bolt holes will line up and kind of float over the lower grommet pins. Curious if anyone else sees the same, or if...