Finally got my kicker combo installed - 500.1, l7t and the gearshade box. Pretty happy with everything so far even though I need to fine tune it a little as well as reinstall all the rear panels.
I followed what gearshade had recommended as a good starting point for the amp, but I feel like...
I ran the 200.4 power through that grommet, it was easy and straightforward. The issue I have had so far was getting that b pillar off so I was trying to avoid doing that a 2nd time on the drivers side. Passenger side is already off.
I was hoping to pull the wire under/across the dash but...
How’s everyone routing their amp power to the rear? Trying to figure out the best/easier way since my passenger trim is taken apart.
I couldn’t easily see if there was a rubber grommet on the passenger firewall like the drivers side.
Can you route it behind the dash?
Any tips and pics...
Took apart the dash tonight, luckily the LR just plugged into the white connection that goes into the head unit. Just had to find the empty holes and snap the wires in. Easy enough.
Got all my parts in this week so I’ll be installing the 500.1, gear shade box and a 8” l7t hopefully this weekend.
Correct, I bet it probably is the older harness. When I talked to Joe I told him I had bought the 200.4 last year and wanted to add the 500.1 so let me know what to get. He didn’t give me a kit number, just sent an invoice for the 500.1 and power harness for the 200.4. I’m going to shoot him an...
Here’s what I have going on.
The two ?? Is what I am unsure about.
PNP included that wiring diagram and I’d imagine the LR wiring goes into that white connector on the bottom right that you screenshot?
Thanks for that. I’ll take some pics when I get back home.
Pretty sure mine is very similar to your setup.
I have a 2022 OBX with high package. Bought the pnp harness and 200.4 last year then just decided to do the sub amp combo since it needs it.
@RagnarKon do you have additional pics of how everything is wired/connected? I bought the plugnplay kits as well and trying to understand all this before I start.
I guess that load resistor wires go into the connection into the 200.4 connection?
Where do the rca cables go to and from? I see...
They’re barely long enough. If you look at my previous post, you can see the red and yellow wire going to my aux wiring. The black ground fit on the right most screw.
It worked as is - but barely.
I saw another wiring harness near the top of the bumper and ran it above. There’s a rubber-ish cover at the top that I was able to get my hand in and feed the wire through. I used some wiring poles to help guide it and made it a lot easier for me.
Edit: here’s a...
Just got mine installed. Took a little over 2 hours for me. Biggest pain was getting the wiring over to the passenger side and figuring out what the best route was.
i ran the wire down from the engine bay first and found a nice spot that went right down to where the drivers side fog is and...