I do like my marine grade vinyl a lot, but I already have three small cracks from daily use on the drivers seat above the stitching on the side of the seat. It is not nearly as “heavy duty”or thick as vinyl used on a boat or snowmobile. I have recovered seats on a sled and a wave runner in the...
My hood fluttered before I installed the Aeroskin. I already had some rock chips on the front of my hood so I installed the Aeroskin light shield. It does appear to divert the bugs. I have taken mine through a touch less car wash roughly ten times..
@Jaymanire did you tap into the turn out (pin4) or the turn control module(pin2)? I have solid connections and no lights. I used 2,9 and 10. Not super difficult to double check the orientation of the plug plus 9 & 10 are the only ones used in the factor plug in the second row. P
Mabett didn’t design anything. They are a reseller that likely has some connection to the company listed below and therefore able to get their hands on some of the designs. They show all of their design work. If you want to see what may be coming out soon, check out their alibaba page and soon...
Here is what the OP is referring to. See the red cylinder? That is where there is a gap that is between the edge of the mic panel and the roll cage. On a side note, this is a perfect ledge to grasp onto when the panels are off and the windows are down/doors are off.
Hey Mike, I was just wondering if you guys had any updates on the hardtop version? Did the zippers come in? I know the constraints are real for everyone right now. I was just curious :).
After having a Bestop Bimini for years on our wranglers, I was tempted to order from them again.
You know how Ford addressed a lot of pain points that Jeep owners have had? This is exactly what JTopsUSA has done with their design compared to competitors. The video at 85mph with minimal...
I dig the build. I routed my lights behind that panel. This looks to be their north location based on the county disability building and former OSU branch (now OLSD STEM building) in the background. Do you have any pics of their two door build? It is sharp. I’m 10 mins away if you ever need...
Nice job! My waterproof rokk charger is setup similarly and charges okay. Defiantly not as fast as the mag safe but it doesn’t overheat like the factory one does. I used a fuse tap into an empty circuit and all connections are soldered and heat shrinked. I have the rubber mat in place on top of...
I installed the curt. I purchased an extender to put in for bikes, but my snowmobile trailer I can hookup unloaded without swinging the tailgate open. I went with the Ford harness which took a substantial amount of time to install, but wasn’t hard. The next week curt came out with a plug and...
Tow package is on list and has been for months. There are constraints all across the supply chain. Have you tried to build an engine in the last year it buy a crate motor? Difficult to buy a motor or even build one because parts are hard to come by. How do I know? I work in the automotive...
I can’t remember the internal diameter I used but it is listed on their site. I did zip tie it on and it makes it easier to put on and to stop the flow when just trying to drain a small amount.
I learned the hard way about why they include the rubber pieces to put on the lip of the doors for removal/install. I now know EXACTLY where to put them since I am missing paint.