I still had to trim the top of the front flaps, but I did not cut a hole.
Removed left and right steps without removing the bracket. They are identical on top.
Installed the mudflaps.
Put the left step on the right side, right step on the left side. Slid steps until they barely touched the...
I ordered a set of switched from sPod. We talked on the phone, they were very helpful and are sending something that may work. There will be a write up and a part number will be added to their website if it works out.
https://www.4x4spod.com/
Installed today using six nutserts. The table is nice quality, and less than $100. I purposely offset it to the outside to give room for another accessory on the inside.
The Rough Country spacers work perfectly for a minor adjustment if you need a little rake, five minute install. It squatted way down when I hauled a load of firewood the day I bought it - and that was bone stock - and on the way home from picking it up.
We did a non squatch BL last week, 1.5" Fabtech front, 1/2" of Rough Country spacers in the rear. The Rough Country comes with Four 1/4" Shims for the top, two 1/2" for the bottom front (because of leverage 1/4" spacer = 3/8" to 7/16" of front lift). The top shims work on the back to give 1/4"...
I have the wiring side handled, just need the switches. I have the part numbers, the switches are cheap, its the bezel that's $400+. Plenty of people will never use the switches.
I would gladly trade my sunglass holder for the switches, I will even send mine, pay for shipping both ways and wait for the return. I'd even throw in $100. The aux switches somehow dropped off my order and I need them.