I just used stainless steel washers and nuts with the provided bolts. I forget which product I had at my shop but I used some anti rust spray on where I drilled into the bumper. I plan on adding some j-b weld around the plate that mounts to the bumper but temperatures here in northeast Ohio have...
This particular bar is very low profile. Even if I mounted the light on the top I think there would have still been 5-6” of clearance between the top of the light and the bronco lettering.
Thanks! Yes- Same three bolts. Will need to trim the top steel tab on the bumper that the plastic cover around the tow hooks. Also, a tad bit of the plastic cover needs trimmed as well. That part will be self explanatory if you try it.
I had to mount it myself, the capable bumper does not have any mounting points. However, I think it would take me less than a hour to do this whole process over again.
Thank you! Yes- I added that same brush bar, the light is from extreme terrain, ford performance hooks, and gear America shackles. The idea was a combination of stuff found from the good folks on this forum.