Search results

OP what opener did you use?

I'm in the same boat as you, just did the modular bumper Warn winch kit and ARB skid plates in my 2dr base 7MT, measured it dropped about 3/4" Did you find any good solutions yet? I'd also prefer not using spacers, leaning toward just a lift kit where I'd go ~ 2" front and 1" rear to balance...

Looks awesome! I would swap the side steps for some more simple tube rock sliders, those look very modern.

They said manual so has to be 2.3L

Oof that is terrible. Not only is it the opposite of seamless in fitment, even if it was the right width it’s still hideous.

this is a half door:

Not really a “half door” just a tube door

I dint have a drip either but it’s under warranty and shouldn’t have a leak like that at 11k. Dealer didn’t put up a fight at all.

I sent my dealer this picture and they got me in the next day

Just noticed it on mine as well, gonna try to check torque if I can find the specs, time to call the dealer.

What you really want is a 255/85R16 which is roughly a 33”x10” perfect for the old school pizza cutter look (and very functional) I was looking for this exact same thing for my base 2DR because the proportions are just right. Unfortunately a couple years ago the only options in that size were...

What’s the part number? I can’t find it when searching by bronco

Dirt Every Day definitely did it best

you’re gonna be looking for that pump for a while haha

is this based on the instantaneous gauge or have you calculated it somehow? Genuinely curious, I drive a lot of highway and hadn’t noticed this but I’ll watch more closely this week

Yep I’m still waiting too, 4/11 blend, marked built 4/14, nothing since. Two months now, both dealer and Ford chat say it’s just waiting on shipping, no holds. I’m in OH so it’d be a pretty quick convoy.

Where in NC? I may want just the 265s…