Search results

Hello, I see you tan the wire down the drivers side. Did you hook up the factory wire with fuse to the vehicle and then run the smaller wire for the on/off button to the auxiliary switch in the glove box or engine compartment? Thanks

Installing took about 3 hours. I had to remove the rock rails from my badlands bronco. There are some tight areas to get tools in. Haven’t drilled anything yet as it said for the lights. Im gonna try to instal the lights wires through the holes already in the bottom. Right now the side mirror...

They do. Fast shipping and good quality product. I recommend.

I had only seen this one on another Bronco from YouTube. Bought it and put it on. Comes in different options, I went with flat black. Ridergraphixs has more options.

No. Just what it came with.

No kidding. Especially the back drivers back bolt. I used a couple of extensions to maneuver to tighten the bolt. Just the ease of getting in and out. I’m glad I’m not the only one who loves em. And it hides all the holes on the bottom.

Good eye

I hate when that happens!! Thank You

From the way it looks on the Bronco its in line with the body of the vehicle. I don't plan on doing much off roading, but boy its so much easier to step on the power step then inside the vehicle and vice versa.

Prob overkill on the photos but you can never be too certain without the proof

I know what you mean. I’m trying to sell my wheels and tires.

I will when I get home.

and instructions say 3-5 hours.

To It took me and my dad 3 1/2 hours. Took 30 minutes to remove all the rock rail bolts and nuts. Pretty easy, just has long bolts and some confined areas. Took 10 minute to wire up with the OBD plug and crimp 4 wires with supplied wire connectors.

Sorry for the delay, been busy working late. Here ya go! Sorry been working late. Here ya go, retracted!

14 “ from the floor and looks to be about a foot to get in.

3 lugs, I bought another center cap so can cut the center out for the rear camera. I still have to put my Rough Country reinforcement and relocation bracket and my XGlow 5th brake light on.

The harness is just like a y-splitter. just leaves an open OBD port. You don't have to purchase it. If you don't purchase it you just have to unplug the Plug and hook up your diagnostic tester or what other device they have that plug into the OBD port. When you done then you just plug the power...

I bought it so in the event someone needs to access the OBD port for anything, no one has to go under the dash and unplug anything. And they do sell the power set override switch as well.

https://broncobrigade.com/amp-research-powersteps-ford-bronco-2021 https://www.autoanything.com/nerf-bars/amp-power-step-running-boards