Search results

Yeah, I saw your post. It helped. when I move the wires I’m going to try to reseat the sub and stick it back some. I do have some of that kilmat behind it and I know that’s also making it protrude a little bit.

I circled the wires. I have running over the top of the stealth box. I believe that is what’s keeping the panel from sitting all the way down and fitting those top two studs. Also the bottom of the JL stealth box itself. The bottom corner is sticking out some and making the panel push out a...

I too have installed the JL stealth box with MoBridge Amps. I’m having a heckuva time getting the trim panel back on. The stealth box sticks out a little bit, and I have some the wires running over the top edge that are keeping kind of where yours was rubbing the question I have is, did you cut...

What does it show when the vehicles running? Is it just the gauges? Rpm? Boost?

Do you guys leave your pro Cal tuner plugged in while driving and use a suction cup to read display or do you keep unplugged?

You must’ve got a good pair. The quality is not consistent. Glad to hear you’ve had a good experience- BTW mine are lubed up. A couple of people replied with good experience, but there’s also many on here that have had many issues with these Ac fab disconnect.

That is good to know. do you have a picture of the updated studded heims?

100% correct

Yes, they start rattling very noisy. Do not connect back up easily. Premature Wear seat at mounts. Lower pin wears down in 3 months. Sounds like the guys making them out of his garage and the quality is not consistent. Stock connectors have articulation in them. The AC fabs do not allow for...

Beware of these quick disconnects for your bronco. They are priced high and do not last more than two or three months whether you’re four wheeling or not with every day driving. Horrible customer service.

Yes, exactly my AC fabs have been on for six months and now all of a sudden are making tons of noise and seem to not allow proper articulation and causing premature wear on sway bar mount bushing

Do you notice with the AC fabs when they are connected and you are on a bumpy road or on the paved road that they are very noisy?

Yeah, the O-ring is in there. You can’t put one on the front and back at least with the AC fab kit, way too tight. I don’t think the O-ring is the issue it seems to be the joint.

I’va had the AC fab quick disconnects on my 2023 wild track for the last six months. I have only disconnected them once several months ago and they have been super quiet until recently. They are making a lot of noise going over bumps while driving on the road. I have checked them for...

OK I’m sending it to you now

Good to know my 2023, wild track 2.7 with 10 speed tranny is doing this as well. It now has about 6000 miles on it and feeling it pretty consistently at start and stops.

What is the trick to putting this piece back on? taking it off was tough but the two clips on the right side on the lower right side on the glovebox are not wanting to go back in.

I am getting ready to install my Mobridge amp tomorrow and my JL stealth box seems to me the cloth screen is garbage and it would actually look better with just the metal round sub protruding through. But then again, I’m not sure the cut would look proper just don’t understand why they went with...

Is this amp running just the sub or does it replace the factory amp?

Does anyone know if the amp on the 2023my wild track with Lux package is mounted near the rear subwoofer? I’ve seen pictures of an amp mounted near the factory sub. Is that amp for the whole stereo system or justice sub?