Challenger replacement ... seriously ;)

General Information

MODEL YEAR
2007
MAKE
BMW
MODEL / TRIM
3.0i
COLOR
Jet Black
ENGINE
3.0 Liter, in-line 6-cylinder, (n52)
FACTORY OPTIONS
Manual Roof and Manual Seats
MODS - POWERTRAIN / DRIVETRAIN
Single Mass flywheel conversion and complete clutch rebuild (Rear Main seal, Flywheel, Clutch Disc, Pressure Plate, Pilot Bearing, Throwout Bearing)
HISTORY, STORY, EXPERIENCE, COMMENTS
Bought in September of 2020 with only 40,400 miles. Super clean. Found out clutch was almost dead as had to put a new one in a few weeks after purchase. I'm selling my Challenger ( and already sold our Pacifica) to pay for the Bronco but that would leave us with only one vehicle - the Jeep Gladiator. So I wanted a small, fun car to get us by until the Bronco arrives and I wanted a manual. I bought this. Its not Challenger fast, but its nimble and fun. I'd forgotten how much fun a stick can be.

Comments

I see Arizona license plate in the back, if you decide to sell this one please pm me, I could be interested, I am thinking to replace one of my Miatas with that or a 335is .
 

Item information

Added by
rjkmoto
Views
482
Comments
1
Last update

More in Other Vehicles

  • 1966 Custom 500
    the lowest model of the Galaxie line, no radio, no power anything
  • 1965 Mustang Coupe
    Something to keep me busy until the Bronco shows up.
  • JETBLACKJK
    Started from stock, and 7 years later its here. Took some time, but we...
  • 43 year old Dodge
    Ordered and Bought new December 1978. Fully documented.
  • Pavement fun
    Doesn't go off-road, but I love driving this car on pavement!

Share this item

Advertisement
Top