37” Tires on my Bronco and I’m in love all over again!

[Benzo520]

Did you do anything to correct the axle geometry from the spacer lift? New control arms or anything like that?

According to the company that made my lift, the geometry wasn’t changed much. They played around with different ways and variants to make the lift and the one I got was the best way to do it without jeopardizing broken axels or tie rods. I’m still considering new UCA in the future just to be on the safe side…

Sponsored

 

[rguest3]

Was the Front End Alignment still within Spec?

 

[Benzo520]

It's cool but I wish people would go out and get all the answers before posting.
Go get it dirty and twisted up and let us know. There are many of us interested but no one wants to try to make them rub.
Thanks brother. It awesome.

So after a few trails and trying to find things to climb, I did rub on the rear fender liners. A bigger lift will be needed or maybe some travel limiters?

 

[Sassy BD]

looks good, dog. I like it.

 

[PWillette]

So after a few trails and trying to find things to climb, I did rub on the rear fender liners. A bigger lift will be needed or maybe some travel limiters?

By all accounts I have read, 37s work best w/ 2-2.5" of lift.

 

[Broncotrax]

So after a few trails and trying to find things to climb, I did rub on the rear fender liners. A bigger lift will be needed or maybe some travel limiters?

Hey thanks for the follow up! I'm jealous man. Enjoy!

 

[BroncoBilly22]

Installed a 1.5” spacer lift front and back
Tires are 37 x 12.50 x 17 Mickey Thompsons Baja MTZ P3 on stock Sasquatch wheels.
No rubbing noticed so far but haven’t gone off road (I sense rubbing once I do that).
Getting a spare tire mount made to fit the tire on the back.

Does that BEAST fit in your garage now? Looks like it would have been a tight fit before the lift and tires?

 

[Benzo520]

Does that BEAST fit in your garage now? Looks like it would have been a tight fit before the lift and tires?

Yea still fits in the garage with some room to spare. I can probably go another 1” on the lift and be ok

 

[Richw23]

Installed a 1.5” spacer lift front and back
Tires are 37 x 12.50 x 17 Mickey Thompsons Baja MTZ P3 on stock Sasquatch wheels.
No rubbing noticed so far but haven’t gone off road (I sense rubbing once I do that).
Getting a spare tire mount made to fit the tire on the back.

love it and i agree 100%

 

[Valhalla]

It's stupid expensive, however I'm considering the "Baja Lifts: kit and o 4.75 offset wheel in the rear with a 2 " offset front... this kit widens the front 6 total inches and replaces the front axle shafts...king shocks are on stupid backorder so probably a lifted fox 2.5 coil over.

Sponsored