4wheelparts (4WP) skid plates look good

[chtucker]

Have not seen anyone post pics of the 4wheel parts skid plates. I am usually down on 4wheelparts for all their offshore manufacturing, but this stuff looked good!

Sponsored

 

[Bison]

Yup very nice. I am hoping rock hard gets some ready to go very soon!!

 

[da_jokker]

Yeah I watched their videos and all I could think about is how broke I'm going to be after buying crap for my Bronco.

I wish someone could figure out a way to mount a winch without blocking the trail cam.

 

[Felix808]

Yeah I watched their videos and all I could think about is how broke I'm going to be after buying crap for my Bronco.

I wish someone could figure out a way to mount a winch without blocking the trail cam.

Just get a winch without the top mounted solenoid and you should be fine.

 

[JesseS]

Just get a winch without the top mounted solenoid and you should be fine.

Or just re-locate the Warn solenoid pack inside the engine bay.

 

[TRACKTOY]

HI
RICOCHETOFF ROAD UT MADE THE BEST SKID PLATE FOR ATV,UTV,TOYOTA BEST IS UHMWPE SKID PLATE NO RUST AND SLIP OVER THE ROCK, AND NO RATTLE AT ALL.JUST BE PATIENT AND THEY WILL BUILT SOON....
TRACKTOY

 

[MSparks909]

Hoping Artec and Metalcloak bring some Bronco skids to market. Both companies make *great* Jeep skid plates

 

[395N]

Genright.

 

[Fedexman1978]

I know it's just prototype stuff, but those welds on the bull bar and winch plate are some J.V. level stuff. Yikes.

 

[Merc4x4]

Just get a winch without the top mounted solenoid and you should be fine.

Or just re-locate the Warn solenoid pack inside the engine bay.

That's most likely not going to help. If you look at the front camera display without the winch, you can see the front edge of the bumper on the bottom of the screen.
It's not just the height of the winch blocking the camera, it's the length away from the bumper.
I'm thinking the solution is to cut the grill and mount the winch as far back as possible. Relocating the solenoid pack will help fitting the winch in the grill cut-out.

 

[Lorenzo]

Maybe those skid plates could be made out of some sort of light weight carbon composite.....

 

[swooshdave]

Maybe those skid plates could be made out of some sort of light weight carbon composite.....

Rocks and composites don't tend to get along.

 

[Lorenzo]

Rocks and composites don't tend to get along.

my point in a different thread - I was being facetious
ARCHETYPE RACING - was proposing composite skids
https://www.bronco6g.com/forum/thre...ng-into-bronco-parts.14176/page-5#post-519689

 

[Rivers90]

When will we see prices for this stuff? I can't really plan what I will get till I have a price.

 

[Chrism81]

When will we see prices for this stuff? I can't really plan what I will get till I have a price.

I believe in one of the videos they said the bronco stuff would be available before bronco's hit the road. So hopefully soon we will have an idea of price.

Sponsored