Aux switch connects

[Browp24]

I was connecting lights to my fuse box in the engine compartment since I do not have aux switches. While doing this I noticed that there are what look like the wires that would essentially be the aux switches. (I assume the same since they look similar to what I have seen in videos). Do these wires go any where or are the hooked to anything?

 

[j_anderson]

https://www.bronco6g.com/forum/thre...talled-diy-writeup-instructions-photos.35388/

They are partially wired. This thread talks about retrofitting the AUX switches after purchase. There are harnesses, switches/bezel (complete overhead console) and different underhood fuse panel needed to make it happen.

IIRC, the underhood wires eventually terminate into a connector in the A-pillar(s) where another harness is needed to take them the rest of the way to the switch location.

 

[Browp24]

Thanks I appreciate it. I will take a look at this thread. I am not really looking to install them. I just put in the oracle bronco lettering lights and wondering if I Hook them up to what essentially would he aux switch cables, would they come on when the car is started? I understand by doing this I would not be able to switch them on and off which I am not worried about

Sponsored