Baja Designs 6x XL Linkable Installed on Bumper

[4x4TruckLEDs.com]

We received our Baja Designs XL Linkable Kit for the bumper today and wasted no time putting it on (well okay I had to wait till I got home, as I was way too busy again today, since we got some Baja Designs Fog Kits in stock we were busy shipping back-orders out)

This kit includes everything you need, outside of some common hand tools

A tip for you during installation if you get this kit... get yourself a 1/4 ratcheting wrench and a hex bit set with a 1/4 shank. When you loosen the center lights up for installation, it's going to be difficult to re-tighten them with the provided allen key. If you use a tiny next bit (one that normally goes in the end of a screw driver) and a ratcheting wrench (not 100% necessary a 1/4 wrench will do) you can make life a lot easier.

This kit is available here and as always, PM me for pricing

https://www.4x4truckleds.com/vehicle-specific/ford-bronco/2021-bronco/

Sponsored

 

[Herbie]

Looks pretty sharp Adam.

 

[broncbeau]

I like!

 

[dweskamp]

We received our Baja Designs XL Linkable Kit for the bumper today and wasted no time putting it on (well okay I had to wait till I got home, as I was way too busy again today, since we got some Baja Designs Fog Kits in stock we were busy shipping back-orders out)

This kit includes everything you need, outside of some common hand tools

A tip for you during installation if you get this kit... get yourself a 1/4 ratcheting wrench and a hex bit set with a 1/4 shank. When you loosen the center lights up for installation, it's going to be difficult to re-tighten them with the provided allen key. If you use a tiny next bit (one that normally goes in the end of a screw driver) and a ratcheting wrench (not 100% necessary a 1/4 wrench will do) you can make life a lot easier.

This kit is available here and as always, PM me for pricing

https://www.4x4truckleds.com/vehicle-specific/ford-bronco/2021-bronco/

I bought 2 LP6s from you. No bronco yet pushed to 22. Going to bumper mount them. Hard to get ideas with only mod bumper pics. Probably going to have to drill. Any recommendations?
Also put together the end cap Kit and have the diode A pillar with brackets coming.

 

[4x4TruckLEDs.com]

I bought 2 LP6s from you. No bronco yet pushed to 22. Going to bumper mount them. Hard to get ideas with only mod bumper pics. Probably going to have to drill. Any recommendations?

I assume you have the standard/plastic bumper? Yeah you'll need to drill. I'm not famliar with mounting points on the plastic bumper

 

[dweskamp]

I assume you have the standard/plastic bumper? Yeah you'll need to drill. I'm not famliar with mounting points on the plastic bumper

It's a badlands with mod metal bumper

 

[4x4TruckLEDs.com]

It's a badlands with mod metal bumper

Ohhh... well then you could just do 2 of them, 1 on each side using the factory bolts. That would be the easiest.

 

[4x4TruckLEDs.com]

Some more shots of the truck and kit

Sponsored