You guys might have already seen this, from BN:
Sponsored
As shown in the table above ’better’ means closer to factory offset. 0 offset is going to change your scrub angle and is more likely to rub on the outer fender under compression.sorry - my math was wrong 55mm is over 2 inches. When you say 'better' - 2 inches inboard would almost certainly rub fenderwells and potentially contact steering components, no?
What’s difference in height between BL height and BD height ??We just don't know for sure until we get these in customer hands. It should be fine if you keep the wheels close to factory sizes (like mentioned above), but we don't know if you'll need to lift the suspension from stock height to Badlands height to do it without rubbing.
That's the million dollar question.What’s difference in height between BL height and BD height ??
It's on my list to measure a BD today.That's the million dollar question.
Somebody did just measure the Badlands aganst a Squatch, frame to axle. I think it was 1/2" lift on the Squatch.
https://www.bronco6g.com/forum/thre...-badlands-suspension-height-difference.15913/
Now we just need a Base/BB/BD/OB measurement! The assumption being they all sport the same suspension.
The hero we needed!!!BD measurements. 6", same as Badlands!
Hopefully that makes some people's day. Same height, just lighter duty. 33s for everyone!The hero we needed!!!
Thanks a ton!
I can't believe Badlands is the same as the standard suspensions!
LOL, you have no idea....!Hopefully that makes some people's day. Same height, just lighter duty. 33s for everyone!
God dammit man focus!!!! Instrument cluster.... Come onnnnn lol285s will fit stock BD wheels too.
They didn't turn it onGod dammit man focus!!!! Instrument cluster.... Come onnnnn lol
And the Dash pad comparisons?! LolThey didn't turn it on