Bronco LED Shop - Plug & Play LED Grille Lights

[niterider006]

Bronco tax strikes again! It's really $25 worth of parts that any novice can put together. Here's the video.

Sponsored

 

[H - 2 CHARLIE]

I guess these are just running lights .

 

[Trueblue2296]

We have been thinking about adding a white option, trying to get a feel for demand!

I'd get one right now if it was available.

 

[LadyBronco]

Ordered I am not mechanically inclined whatsoever. I hope it’s as easy to do as it looked in the video

 

[Fireman Dave]

If these were offered with a smoked lens I would be all over them. Nice video!

 

[broncoledshop]

Is this going to be offered in White?

We plan to add a white LED option towards the end of May!

 

[broncoledshop]

Looks amazing! Thanks for the photo

 

[broncoledshop]

Ordered I am not mechanically inclined whatsoever. I hope it’s as easy to do as it looked in the video

Our goal is to make installation as easy as possible, feel free to send us a message or DM us on Instagram if you need help with any of the steps!

 

[broncoledshop]

If these were offered with a smoked lens I would be all over them. Nice video!

I like the idea.. we'll look into it!

 

[Fireman Dave]

Awesome, I will buy your first set of smoked lenses!

 

[Shane78]

Bronco tax strikes again! It's really $25 worth of parts that any novice can put together. Here's the video.

Exactly what I thought. $130? bruhhhh. They are $18 on eBay for a pack of 4, including the harness, $30 on Amazon. At least if those fail you don’t feel as bad for spending a lot!

 

[TX-Hans]

From the OP/seller’s install video, I did not see what their solution was to allow the hot lead to enter the fuse block (for the fuse tap) and the fuse block cover to go back on with a proper seal. I built my own set (using smoked lens) and found you need to modify the fuse block cover to allow the wire internal access in order for the cover to properly reseat into the channels that seal it off from the elements.

 

[SubmarineNuke]

Got mine today and did the install. Looks clean under the hood. Only question is the wire sticking out of the fuse box. Any solutions for that and making sure the lid closes firmly and locks all around? Anyone?

 

[broncoledshop]

From the OP/seller’s install video, I did not see what their solution was to allow the hot lead to enter the fuse block (for the fuse tap) and the fuse block cover to go back on with a proper seal. I built my own set (using smoked lens) and found you need to modify the fuse block cover to allow the wire internal access in order for the cover to properly reseat into the channels that seal it off from the elements.

Got mine today and did the install. Looks clean under the hood. Only question is the wire sticking out of the fuse box. Any solutions for that and making sure the lid closes firmly and locks all around? Anyone?

Looks great! If you have a small round file, you can make a small notch in the fuse box edge so that the wire can run through but the lid will still close.

 

[jimi1851]

Just got done installing mine. I ended up using one of the upfitter switch fuses (#63) because the recommended #21 fuse has no guts to make a connection. There are no fuses for the recommended parking lights or ignition that I can find. Also, be careful disconnecting the camera and washer fluid connectors, I broke the tab off of the camera connector.

Sponsored