Does anyone know what speaker wire harness connector the Bronco uses to replace the dash and rear OEM speakers?

[bigbeyer]

I want to replace the speakers on the bronco, and already have tried, but i do not want to cut and solder the wire in, does anyone know what the name/part number the new Bronco uses so i can justy buy the adapter to plug and play? I have tried a few through googling already and none of them fit so far.

Sponsored

 

[Gobraphil]

Check a couple of the threads here. Nothing so far on the 4 in speakers

 

[WheresMyCar]

I think so far it’s not made. You would need to build it with the correct mollex connector.

 

[schlava]

Any update?

 

[Compta38]

This is relevant to my interest. I want these in hand for later if available.

 

[Johnny Mo]

Crutchfield has an entire page of harnesses with a "Cannot confirm fitment for your vehicle"

 

[flip]

https://www.bronco6g.com/forum/threads/4”-speaker-harness-pics.21393/page-4#post-780148

 

[94Bravo]

If you take a picture of the connector take it to a Ford dealer. The parts department may be able to match it up with another one. The Bronco is so new that I am not sure they have the info on a pigtail yet but they might. Good luck!

 

[Pressurized]

https://www.bronco6g.com/forum/threads/4”-speaker-harness-pics.21393/page-4#post-780148

This is the correct parts to create the connector. Unfortunately, it's still soldering and fabricating at this point. No mass produced adapters are on the market yet.

 

[flip]

This is the correct parts to create the connector. Unfortunately, it's still soldering and fabricating at this point. No mass produced adapters are on the market yet.

Correct. Ford does not make a pigtail for this side of the harness since the "female" side is part of the speaker and not a wire to wire connector. Same for the kick panel speakers.

 

[Contact]

What are the positive colors of the wires for the front dash speakers? Not the kick panel

Sponsored