Everglades fender flare part numbers and price?

[BottleShark]

I've look to see what the fender flairs on the Everglades cost but can't find it. How would I go about finding a price? I would like to swap out them to my bronco.

Sponsored

 

[drew707]

I believe the actual fender sheet metal is different too so you would need those. Then you would be stuck with a hole for the snorkel on the front right to deal with

 

[BitterBronco]

I believe the actual fender sheet metal is different too so you would need those. Then you would be stuck with a hole for the snorkel on the front right to deal with

Agreed - they’re not swappable with the rest of the lineup. The sheet metal is significantly different

 

[Boreal]

I believe the actual fender sheet metal is different too so you would need those. Then you would be stuck with a hole for the snorkel on the front right to deal with

If OP is wanting the snorkel too, this isn’t a bad option

Agreed - they’re not swappable with the rest of the lineup. The sheet metal is significantly different

All bronco fenders are attached with basic hex hardware and are 100% removable/swappable, It’s unlikely that ford would change the mounting method. The flares themselves won’t be interchangeable due to design differences between the rounded and squared wheel arches, however.

Everglades Trim bits should theoretically bolt onto any existing bronco thus far

 

[cigartexan]

This is another option!

https://www.advfiberglass.com/collections/ford/products/2021-ford-bronco-fenders

https://www.advfiberglass.com/collections/ford/products/2021-ford-bronco-rear-quarter-kit

 

[BottleShark]

Hopeful someone will make flairs that look like that as bolt on.

AND, I like snorkels and know how much they help with clean air BUT that might be uglier than the Raptor fenders........

 

[Little Foot]

Has anyone bought and swapped the Everglades/Heritage fenders yet? I’d like to take a look at doing it myself, part numbers, friction points, etc…

 

[CoolContractor]

Has anyone bought and swapped the Everglades/Heritage fenders yet? I’d like to take a look at doing it myself, part numbers, friction points, etc…

Following. Bump.

 

[rad_rob]

I just came across these this morning:

https://andersoncomposites.com/prod...glades-style-fiberglass-front-fenders-2dr-4dr

https://andersoncomposites.com/coll...tyle-carbon-fiber-front-fender-flares-2dr-4dr

These look pretty good, but definitely pricey.

 

[mjcutri]

I just came across these this morning:

https://andersoncomposites.com/prod...glades-style-fiberglass-front-fenders-2dr-4dr

https://andersoncomposites.com/coll...tyle-carbon-fiber-front-fender-flares-2dr-4dr

These look pretty good, but definitely pricey.

$1k per pair! For Flares!?! That is the wrong use for carbon fiber...

 

[rad_rob]

$1k per pair! For Flares!?! That is the wrong use for carbon fiber...

Yeah, definitely expensive. Especially when its a consumable item if you wheel your Bronco a lot haha

Sponsored