Ford made a change in 2 Dr tops ?

[JL8jeff]

It looks like the top is around 62-1/2" to 63" wide at the bottom front measured on my 2 door. Some info I see shows the F150 bed to be 65" inside the rail up through 2016 model year. I don't see the inside width listed for years after that. So it might fit, I'm sure your would need to rest it on the inner wheelwells.

If you wanted to put it in sideways, the top is around 51" from front to back at the bottom of the top which is the longest point.

Sponsored

 

[Rydfree]

It looks like the top is around 62-1/2" to 63" wide at the bottom front measured on my 2 door. Some info I see shows the F150 bed to be 65" inside the rail up through 2016 model year. I don't see the inside width listed for years after that. So it might fit, I'm sure your would need to rest it on the inner wheelwells.

If you wanted to put it in sideways, the top is around 51" from front to back at the bottom of the top which is the longest point.

Thanks, sliding it in sideways sounds like the way to go .

 

[The Pope]

You could turn it Upside down with several same size cardboard boxes (or something else to distribute the weight) to hold it slightly above the wheel wells (with some padding on the wheel wells as well). Have the rear part of the top close to the cab of the truck. This way it shouldn't catch any air.

Just a suggestion...

 

[Rydfree]

You could turn it Upside down with several same size cardboard boxes (or something else to distribute the weight) to hold it slightly above the wheel wells (with some padding on the wheel wells as well). Have the rear part of the top close to the cab of the truck. This way it shouldn't catch any air.

Just a suggestion...

It is about the same width as length so just had to angle it in the bed. A couple straps, a blanket and it rode home fine. The complete top with glass, two front panels and a Ford bag to put the panels in for $1000 so couldn't pass it up. It is off a First Edition that the owner put a soft top on. It actually looks better than anything I have seen of late. The dealership called and said my Bronco was ready so went and picked it up after we got back. They just went ahead and took one off of a 24 model they had on showroom floor. I'll just tuck this one away for a spare. The new one has the honeycomb and a couple waves but nowhere as bad as the last one had. Will just have to live with it as long as no cracks appear later. Still have 16 months of warranty left and now I have the spare so not concerned too much now.

 

[JL8jeff]

Good deal, I've seen a few posted around here for sale in that range and I'm tempted to grab a spare but I don't have 6K miles on my truck (daily driver that I only go out a couple days a week) that is almost 2 years old.

Sponsored