Here you go.Do you have a side view photo of this? looks like a good solution
Sponsored
Here you go.Do you have a side view photo of this? looks like a good solution
Nice job - thank you!Here you go.
Had a chance to use it yet?Here you go.
Where did you get that mount? Also how did you the coax back there? Looks nice!Yes took it to Moab this last week. Used a second unit with magnetic base antenna on my F150 and communication between the two vehicles was fantastic. Almost no static and quite pleased with the range. At home we tested between a handheld walkie talkie and the unit in my Bronco and the handheld was able to hear me 2 miles away and they were inside our house.
Made the mount from a piece of steel from Home Depot. Ran the coax over the top of the roll bar and down the pillar behind the rear door under the rear passenger step plate and under the drivers seat into the center console. Very simple install.Where did you get that mount? Also how did you the coax back there? Looks nice!
Well done!Made the mount from a piece of steel from Home Depot. Ran the coax over the top of the roll bar and down the pillar behind the rear door under the rear passenger step plate and under the drivers seat into the center console. Very simple install.
I have a mxt575 with swr of 1.54 and power output of 48.8 watts.What readings are you guys getting with your set up? I’ll be working on mine Thursday…SWR is a little high At 1.39 and power a little low at 9.47. Running a mxt275. I’m getting better results on my mxt115 in my tundra with a magnet antenna. SWR on a tundra 1.01 and 11.2w power.
Where did you buy the top photos bracket?Different options I’ve been running..
The 3rd brake light mount is from eBay. It’s for a Jeep. Just a heads up, if you have a hard top, the rear wipers will hit it. Going back to my original config..Where did you buy the top photos bracket?
Thanks. If they decide to mass produce I’d be very interested.The 3rd brake light mount is from eBay. It’s for a Jeep. Just a heads up, if you have a hard top, the rear wipers will hit it. Going back to my original config..
This is a custom mount but working with SRQ Fabrications to see if they can mass produce..