GoRhino DSS Steps / Sliders installed on 2021 Bronco Badlands

[4avor8ntfair]

The steps are cool. But what I'm most interested in is where did you get that cursive Bronco where the Badlands badge used to be? That looks Wicked.

https://www.broncodepotusa.com/collections/all

Sponsored

 

[Socal71]

Just finished installing these. Love the fit and look with stock fender flares. The DS6 looked ok on the Sasquatch that was posted but these seem much better for the standard flare.

Nice, now if they would finally make the 2 door version!!!

 

[BroncoUnicorn]

Nice, now if they would finally make the 2 door version!!!

Yes! This was a huge disappointment when I couldn't get these for a 2 door.

 

[Desert_6G]

Can someone confirm if these stick out further than the outtermost part of the door panel?

 

[Zap74]

Can someone confirm if these stick out further than the outtermost part of the door panel?

I can confirm, have these on my BadSquatch

 

[4avor8ntfair]

Amazon.
XPEL Black Universal Door Sill... https://www.amazon.com/dp/B003EP52I8?ref=ppx_pop_mob_ap_share

I’m assuming this 60” amount will probably do all four door sills AND across the back?

 

[Contact]

Just finished installing these. Love the fit and look with stock fender flares. The DS6 looked ok on the Sasquatch that was posted but these seem much better for the standard flare.

were you able to this solo or had help attaching the bar

 

[ATLBronco75]

I’m assuming this 60” amount will probably do all four door sills AND across the back?

No. I did 18” front doors and 12” rear doors. Was barely enough. I don’t feel like I need it on the back at all.

 

[ATLBronco75]

were you able to this solo or had help attaching the bar

solo but I used a floor jack to keep them in place while I attached them. Without a floor jack you’d definitely need help.

 

[Contact]

solo but I used a floor jack to keep them in place while I attached them. Without a floor jack you’d definitely need help.

That's exactly what I had plan to do. Thank you.

 

[JPG]

Still looking for a frame mounted solution to use them as sliders

 

[4avor8ntfair]

No. I did 18” front doors and 12” rear doors. Was barely enough. I don’t feel like I need it on the back at all.

Thanks, that’s helpful. I just glanced at the pic again. Nice attention to detail…I see that you rounded your corners after cutting the strips! I’ll have to remember that

 

[ATLBronco75]

Thanks, that’s helpful. I just glanced at the pic again. Nice attention to detail…I see that you rounded your corners after cutting the strips! I’ll have to remember that

I used a dime to trace my radii. Use a really sharp exacto blade.

 

[MWILD]

Still looking for a frame mounted solution to use them as sliders

This. The Rock sliders on my Jeep are beat to hell and I really don't want anything mounted to the body.

 

[threeonone]

Just finished installing these. Love the fit and look with stock fender flares. The DS6 looked ok on the Sasquatch that was posted but these seem much better for the standard flare.

Do you find these protect against rocks being thrown up at the doors?

Sponsored