Did you have to cut the door sill tape? What did you use for install instructions? Thanks.
It's one 60" piece of tape. No real instructions other than cut it and stick it. As I a said above I cut it into 2 - 18" pieces and 2 - 12" pieces then radiused the corners by tracing a dime onto the tape backer then cutting it with a sharp xacto knife.
That's the part I was looking for. The tracing of the dime.
I liked how your corners were rounded. Thanks.
I just installed the dss sliders today and this was exactly how I did it alone . The floor jack was my best friend .
installed the Go Rhino DSS's I got from @Stage 3 Motorsports (good company/pricing/fast west coast shipping so far!) Go Rhino makes a nice looking product.
it was a one man show, took a couple hours while taking my time and making a couple adjustments. And honestly, unless you have a vehicle lift, I really don't know how "helpers" would be a better option. I did use a "Fishing Magnet" to hold the step brackets in place to get starter bolts in, which was key.
Congrats, It looks great! I think this is what I’ll leaning towards as a step should make it easier for the family. Is the step about 17” off the ground?Got mine on last night and finished this AM. I didn't have a magnet readily available, so I stuffed a shop rag into the slot behind the L bracket. Similar trick I have to do with my Kamado Joe when I put the firebox sections in.
Also used a pair of plastic totes to help balance the rail.
Is that the D6 from Go Rhino?Got mine on last night and finished this AM. I didn't have a magnet readily available, so I stuffed a shop rag into the slot behind the L bracket. Similar trick I have to do with my Kamado Joe when I put the firebox sections in.
Also used a pair of plastic totes to help balance the rail.
Yeah. These are the D6. Honestly didn't realize the width difference when ordering. Probably would've gone a different model, but this will be great for my kids to step in. Still a win win.
