- First Name
- Mark
- Joined
- Mar 4, 2021
- Threads
- 8
- Messages
- 105
- Reaction score
- 241
- Location
- Pennsylvania
- Vehicle(s)
- 2013 f-150 FX4
- Your Bronco Model
- Wildtrak
- Thread starter
- #1
I'm going to be mounting a pittsburgh electric hoist from harbor freight under my carport. This should enable me to remove/install back shell by myself. I have few questions.
1) can you leave the factory roof rails attached (rear mounts of course) and use them to hook onto?
2) where is a good place to strap onto otherwise?
3) how many straps should I use? Was thinking 3 minimum to keep it level while lifting.(2 towards rear where all the glass is and1 dead center on the front.)
I'm really a newbie here and don't want to drop, twist or otherwise damage this mic top.
Sidenote: my wife helped me take it off last night and it was sketchy with her. She said never again.
Forgive me if this was covered. I couldn't find anything relevant in the search.
1) can you leave the factory roof rails attached (rear mounts of course) and use them to hook onto?
2) where is a good place to strap onto otherwise?
3) how many straps should I use? Was thinking 3 minimum to keep it level while lifting.(2 towards rear where all the glass is and1 dead center on the front.)
I'm really a newbie here and don't want to drop, twist or otherwise damage this mic top.
Sidenote: my wife helped me take it off last night and it was sketchy with her. She said never again.
Forgive me if this was covered. I couldn't find anything relevant in the search.
Sponsored