Yes I think so, it's mounted on the main portion of the bumper.Can you still remove the bumper wings with this on?
Sponsored
Yes I think so, it's mounted on the main portion of the bumper.Can you still remove the bumper wings with this on?
My first post.Mounting options
With the parking sensor on the left, you really have to push the plate as close to the right to the recovery point as practically possible. Vertically you have about 1 inch of adjustment up or down.
The 4 screws that mount the plate to the bracket are not normal #14 plate screws they are smaller (#10) and have fine thread. Just a FYI.
Plate angle
There is only 2 angles the plate can be mounted, parallel to the angle of the bumper pocket and flush(ish). Unfortunately there is no option for it to be dead strait without an angle.
I choose the flush(ish) angle in the pictues below. I think it looks pretty sharp!
*Small footnote, in CO any license plate relocation is technically illegal since 2018. Check your state laws and be aware of the risks.*
https://leg.colorado.gov/bills/sb18-028My first post.
This is great information, so thanks. I too live in Colorado, and was wondering if I’m not actually relocating the plate if there is anything technically illegal? So, this would be the original location of the plate.
Thanks. I'll try to keep my dealer away from the front bumper!https://leg.colorado.gov/bills/sb18-028
"Requirement that the front license plate be mounted horizontally on the front in the location designated by the manufacturer."
Interpret that as you will.
The law is once thing, enforcement is another. I personally don't think enforcement will be a practical risk in CO.
Can you still remove the bumper wings with this on?
Definitively yes, you canYes I think so, it's mounted on the main portion of the bumper.
SOLD! I’m getting my Bronco registered tomorrow. Perfect timing. Thanks to both.Definitively yes, you can
Mind showing the install? I also have an OBX with a parking sensors.Drove with no front plate for about two months (Connecticut).
I have outerbanks with parking sensors and was able to adjust the mounting position with no issue with the sensor or fog light. I would highly recommend, and the stubby antenna works great also!
They way I have it installed it does drop slightly below the bottom of the bumper, but if were to go off road, very easy to remove temporarily.Mind showing the install? I also have an OBX with a parking sensors.