Need a European Vin Number

[geoking]

I would like to buy the Bronco European Rear Fog light as I have the High package and a signal feed at the rear. I went to the Ford dealer today and to get to it, they need a Vin from a European Bronco. They showed me the parts diagram and the beginning of the part number is "15K272_____ . the end of the part number requires a vin to look it up. Can anyone with a Bronco in Europe help me out? Or call your local Dealer to get the part number for me? I crawled under an FE on the show room floor and the mounting locations are there and only require clips and 2 screws. PN W710763-S450B. I would like to be lazy and also buy the short harness for the tag light and fog assembly if possible. I can make it, but its already being built. Another Part number needed? THANK YOU.

Regards,
George

Sponsored

 

[Wide Open Roads]

Have you tried checking the European version of cargurus or Autotrader? Maybe you can find a VIN that way.

 

[geoking]

Have you tried checking the European version of cargurus or Autotrader? Maybe you can find a VIN that way.

I have not and will try now, great idea. thanks

 

[Wide Open Roads]

I have not and will try now, great idea. thanks

Don't thank me until you see if it works. Offering an idea is not the same as offering a solution!

 

[geoking]

Don't thank me until you see if it works. Offering an idea is not the same as offering a solution!

NO Broncos listed, but it was a good idea

 

[Bee Bop]

There are not any Bronco in Europe. Those broncos were for the middle east Dubai precisely.

 

[geoking]

There are not any Bronco in Europe. Those broncos were for the middle east Dubai precisely.

Thanks …. Any clue if rear fogs were required ?

 

[fschael]

As far as I know, there is no European version of the Bronco yet, therefore, I don't think you will be able to find one.

At least not yet.

 

[Daktari]

There are not any Bronco in Europe. Those broncos were for the middle east Dubai precisely.

yes, Bronco is not sold in Europe for now, read that it might eventually show up there, but not for a while - if ever.

So what ever the part number is for here in the US is the part number, not sure why your dealer is asking for a EU one?

 

[Bee Bop]

The rear fog is required in Dubai. There is no US equivalent part.

 

[geoking]

As far as I know, there is no European version of the Bronco yet, therefore, I don't think you will be able to find one.
At least not yet.

Thanks. I found in Switzerland and in Germany on Classified listings. However, all the listings interior pictures clearly show 1 fog light image on the headlamp switch. I’ll have to wait for sure.

 

[geoking]

The rear fog is required in Dubai. There is no US equivalent part.

The dealer didn't want a European VIN , ANY VIN with the dual fog and we couldn't find one in the USA . Dubai is beyond me for reaching out to anyone? The part has been designed and molded and my wiring harness has been wired for it. I can always use a SS1 SAE FOG. If everyone will keep this in the back of their mind, MAYBE ILL FIND ONE . I REALLY NEED A BRONCO DEVELOPEMENT CONTACT. SMILE This drawing kinda looks like the lease id in the bumper. The dealer and I found the mounting tabs while laying on the floor in the show room this afternoon. We also found the harness end with the pin 3 populated. Its in the long term planning .

 

[geoking]

the lens may require a different rear bumper cover with an oval opening. hmmmm? so much fun when digging for little unknowns. Its just plastic and there is room for it to tuck up higher than the hitch receiver.

 

[Gotdesl]

I would like to buy the Bronco European Rear Fog light as I have the High package and a signal feed at the rear. I went to the Ford dealer today and to get to it, they need a Vin from a European Bronco. They showed me the parts diagram and the beginning of the part number is "15K272_____ . the end of the part number requires a vin to look it up. Can anyone with a Bronco in Europe help me out? Or call your local Dealer to get the part number for me? I crawled under an FE on the show room floor and the mounting locations are there and only require clips and 2 screws. PN W710763-S450B. I would like to be lazy and also buy the short harness for the tag light and fog assembly if possible. I can make it, but its already being built. Another Part number needed? THANK YOU.

Regards,
George

UAE Bronco VIN:
1FMDE5AP9MLA60399

 

[Silver-Bolt]

Do Canadian vehicles require a rear fog light?

Sponsored