- First Name
- Patrick
- Joined
- Jul 27, 2020
- Threads
- 4
- Messages
- 18
- Reaction score
- 7
- Location
- Davidson, NC
- Vehicle(s)
- dodge p-up
- Your Bronco Model
- Base
- Thread starter
- #1
Help dash display blank
Sponsored
I agree. Disconnect your battery and see if that is a fix. I had a screen go bad on my Explorer at 29k miles. Hopefully it just needs to be reset.Try turning it off and on, or disconnecting the battery for a bit?
How long should I Wait, I have done about 5 min so farI agree. Disconnect your battery and see if that is a fix. I had a screen go bad on my Explorer at 29k miles. Hopefully it just needs to be reset.
Should be good with that. If it doesn't come back up you'll probably need to have warranty claim. I'll check if there is a fuse for the dash display you could check as wellHow long should I Wait, I have done about 5 min so far
Thanks, fuse looked good to meShould be good with that. If it doesn't come back up you'll probably need to have warranty claim. I'll check if there is a fuse for the dash display you could check as well
Tighten her up. Battery terminals and
I did that also, no luck.Check all these nuts.
In the computer world they hold the power button to dissipate the residual energy. I'm sure holding the start button while the battery is disconnected could net the same outcome I think.I seem to have more success leaving the battery unplugged for 30 minutes than 5. So many computers with very little power draw, seems to take a while for all the power to dissipate compared to years past. Unlike the old days of large capacitors being needed for faster startups (Storing power between on/off cycles).
Let's hope it is some kind of a connection or software glitch. Still a decent chance it is needing to be replaced or even have the dealership reset it.
Sorry did not workIn the computer world they hold the power button to dissipate the residual energy. I'm sure holding the start button while the battery is disconnected could net the same outcome I think.