Offset needed for a little “poke” on SAS?

[Greenbrick]

I’ve been trying to determine what offset I need to get on a new set of wheels to ensure a little poke with the SAS fenders. I do plan on getting slight lift (additional 1-2”) Anyone have any pics of a SAS Bronco with zero offset?

I saw an IG post from Maxslider that had -12 offset and it looked pretty good but it was from an angle so hard to tell if it was too much.

Sponsored

 

[BossMann]

I went +20. Just over a 1/3 inch more out than stock and that was manly because any higher positive offset is very difficult to find.

I also went with a wheel I don't love the looks of, but was quite lightweight. Function over form for me.

 

[Oceannomad]

I went +20. Just over a 1/3 inch more out than stock and that was manly because any higher positive offset is very difficult to find.

I also went with a wheel I don't love the looks of, but was quite lightweight. Function over form for me.

Anyone have a pic of what that would look like?

 

[Toccoa]

0 offset from the concept last year.

 

[Oceannomad]

That’s a 0? It pokes a little already

 

[BennyBronco69]

I’ve been trying to determine what offset I need to get on a new set of wheels to ensure a little poke with the SAS fenders. I do plan on getting slight lift (additional 1-2”) Anyone have any pics of a SAS Bronco with zero offset?

I saw an IG post from Maxslider that had -12 offset and it looked pretty good but it was from an angle so hard to tell if it was too much.

If I end up not liking the poke with my Sasq BL I am just going to trade for reg flares vs messing with the offset.

 

[TRMFAM]

Try this...
Wheel offset calculator

This will give you measurements and a visual before / after regarding what the wheel / tire does as in stick out more / less and then you can check out pics of specific offsets.

 

[NewBroncoOwner]

between +35 and +25. I am running +35 and my tires sit flush with base fender flares

 

[Toccoa]

If I end up not liking the poke with my Sasq BL I am just going to trade for reg flares vs messing with the offset.

That’s a good look as well.

 

[Ramble_Offroad]

Watch some of Vaughn G’s vids on YouTube talking about the RTR concept Bronco & RTR wheels. The RTR Bronco wheels (for sas) have a 0 offset and I believe they have a bit of poke beyond sas flares depending on tire choice.

 

[Broncolife88]

anyone have pics of -12 offset on a SAS Bronco?

 

[Jason hamilton]

Method wheels are mostly zero offset. That will be just under 1.25 inches of additional outboard for SAS. Zero offset is 2" out from base. I plan to go up 2"and out 2" on BD.

l like your idea of switching to standard flares. Would you want to swap?

search method or zero offset for pics.

 

[88to21bronco]

Fuel Trophy, +6 offset and 35/12.50/17's with regular flares

 

[Greenbrick]

anyone have pics of -12 offset on a SAS Bronco?

tough to tell from the 3/4 angle how it looks, but I believe this is -12 offset:

 

[Raptor911]

do you know why so many wheels you come across is -12?

-12 is an offset for Toyota truck wheel so it will not be hub-centric for the bronco.

anyone have pics of -12 offset on a SAS Bronco?

Sponsored