Rough Country Nudge Bar and 4" LED lights

[NewBroncoOwner]

Installed the Rough Country Nudge Bar and 4" lights

Sponsored

 

[BRKOBILLY2]

Looks really good, but how does it work with sensors and camera?

 

[Bjj101]

I like the look! Nice job!

 

[MacDonald_Photo]

Looks really good, but how does it work with sensors and camera?

Curious as well.....I like the look as well but want to see how it impacts the camera and sensors.

 

[Ripcurl]

There is no camera on this one.......

 

[NewBroncoOwner]

Looks really good, but how does it work with sensors and camera?

Its a base, No fancy gadgets needed or wanted. So i cant speak on those problems.

 

[Hart4523]

Looks really good! How did you wire in the switch for the lights?

 

[Andy_M]

This looks really good from a license plate solution perspective too.

 

[Andy_M]

Its a base, No fancy gadgets needed or wanted. So i cant speak on those problems.

More money, more problems .

 

[NewBroncoOwner]

Looks really good! How did you wire in the switch for the lights?

**Small Back story: Bought this Bronco as an abandoned Base without the AUX switches.

I Hooked the lights up utilizing the AUXBEAM 6 Gang switch from Amazon. It essentially is the same idea as the Factory Switch. Rough Country lights come with a relay and switch pre wired into their systems as well. I just did some minor re wire to use my switch panel. I knew i should of made a video to help out others.

If you have a GT of 90+, you will have no problem figuring it out. I have confidence in you, brother!!

 

[NewBroncoOwner]

This looks really good from a license plate solution perspective too.

Plate is still connected the the front facia. I have 4 holes i never want to see on there. (thanks dealership)

 

[Diode Dynamics]

Awesome aftermarket bar and lighting setup! Looking good!

 

[CobraKaiSG]

Curious as well.....I like the look as well but want to see how it impacts the camera and sensors.

i read on the website for the bar under the Q&A that according to manufacturer "may interfere with sensors and cameras" so for me it's not worth it

 

[RalBronco]

i read on the website for the bar under the Q&A that according to manufacturer "may interfere with sensors and cameras" so for me it's not worth it

This was enough for me to sit and wait on this bar as well. I don’t care about a parking sensor, but I’m hesitant to disrupt the 360 sensor. While I’ve never had anything like that on a vehicle before, it could potentially avoid catastrophe at some point.

 

[BaseBlackCoupe]

Do you think you could use this bar and mount 2 kc lights using the bar/wiring... I'm curious!

Sponsored