Sasquatch Level and 37s - “Before” Measurements Needed Please

[BroncoZ13]

Hi yall, small favor to ask
can someone with a stock height 4 door Sasquatch measure their height from center hub/wheel to bottom of fender flare (front and back)?

just installed the Bilstein 6100s and completely forgot to get measurements of “before” to check level. I still have a 1.5” rake so questioning how much the front end actually came up.

I used position #5 of 6 on the spring clip for the 6100s, and instructions/specs claim that it should raise the front 2.0” and rear 0.9”, but I don’t think it lifted that much.

Current front hub to fender 23.25”
Current rear hub to fender 24.75”

thank you in advance!

Sponsored

 

[pakrat]

I tossed my measurements but I know I got 1.5" at the front at clip setting #4. I left the the rear at the bottom (stock) clip setting and the fenders are now perfectly level front and rear. Mine is a stock Sasquatch BL that had 1.5" of rake to start with (actually on side was only 1 3/8" low in front) and now both sides are perfectly level and the rears did not move at all.

 

[BroncoZ13]

I tossed my measurements but I know I got 1.5" at the front at clip setting #4. I left the the rear at the bottom (stock) clip setting and the fenders are now perfectly level front and rear. Mine is a stock Sasquatch BL that had 1.5" of rake to start with (actually on side was only 1 3/8" low in front) and now both sides are perfectly level and the rears did not move at all.

Thanks for the feedback on your lift, and I might just go up to local Ford dealer and try to find a Bronco to measure to compare.

 

[rtaylor]

Hi yall, small favor to ask
can someone with a stock height 4 door Sasquatch measure their height from center hub/wheel to bottom of fender flare (front and back)?

Factory ride height specs. Sasquatch = Adrenaline Rush.

 

[Gtrekker]

Cant help you much (SAS, High pkg), didnt measure then....

Maybe y ok y can pull or cypher the measurements from the dimensions sheets when the came out.

Your stance looks like a good!!!

 

[Gtrekker]

Factory ride height specs. Sasquatch = Adrenaline Rush.

Yep, that's one of them...lol

 

[BroncoZ13]

Factory ride height specs. Sasquatch = Adrenaline Rush.

Thanks for providing, but not sure I can compare these specs with my Bronco since I have 37s now which increase ground clearance vs factory tires.
Really need a center of hub to fender measurement as that would be best/easiest way to confirm. Thank you though for sending

 

[rtaylor]

Thanks for providing, but not sure I can compare these specs with my Bronco since I have 37s now which increase ground clearance vs factory tires.
Really need a center of hub to fender measurement as that would be best/easiest way to confirm. Thank you though for sending

Note that tire size doesn't affect the ride height spec. It is only measuring the suspension.

 

[Copperhorse73]

Front 21.75, rear 23.25, this is with 2.7 motor, heavier than 2.3 which may affect front slightly

 

[BroncoZ13]

Thanks Copperhorse, this is great!
Mine has the 2.7 also, so should be same.

So on position #5 for the 6100s it lifted the front 1.5” and rear 1.5”hence the rake

was supposed to make level, but oh well, it looks great now on 37s.

thanks everyone!

 

[Denny3297]

Thanks Copperhorse, this is great!
Mine has the 2.7 also, so should be same.

So on position #5 for the 6100s it lifted the front 1.5” and rear 1.5”hence the rake

was supposed to make level, but oh well, it looks great now on 37s.

thanks everyone!

Any rub with the 37s?

 

[BroncoZ13]

Any rub with the 37s?

Not with the BFG 37x12.50 which run a little small. I also tried the Yoko Geolander 003 in the same size and they barely touched rear crash bar mount at full lock, so went with the BFG instead.

I plan to install this max tire kit that removes the crash bar mounts since the Sasquatch package didn’t use them, and opens up plenty of space for 37s with a level, so shouldn’t rub when wheeling.

https://jksmfg.com/collections/ford-bronco-2021/products/ford-bronco-max-tire-clearance-kit

Sponsored