Short parking sensors wires for new Bumper Vanguard Off-Road Black HD

[drvahe]

Hello, need an advice . Just got a new bumper from Vanguard, the model is Vanguard Off-Road Black HD Bumper VGHDB-2375BK-LED.
Holes for parking sensors on this bump has different location and I am trying to fit harness from old bumper but it looks like short.
My question is can I cut parking sensor wires and extend it a little bit? Thank you

Sponsored

 

[Hemisfear]

Hello, need an advice . Just got a new bumper from Vanguard, the model is Vanguard Off-Road Black HD Bumper VGHDB-2375BK-LED.
Holes for parking sensors on this bump has different location and I am trying to fit harness from old bumper but it looks like short.
My question is can I cut parking sensor wires and extend it a little bit? Thank you
[/QUOT
I followed the JCR video for their winch mount when installing my Amazon Special

winch mount, they instruct to open up the harness to gain the length needed, passenger side worked great for me, the driver is a bit tight but works.

 

[drvahe]

I opened and had gained a little bit but still not enough

 

[Elevator Man]

Yes, you can cut the wires and solder/shrink tube in an extension. I had to do it with my sensors a few months ago on my new BAMF bumper. No issues.

 

[Crash98]

If you cut back the tape on the harness, you should gain about 6-9 inches. I had to do this when installing my test bumper.

Sponsored