Stabilizer bar disconnect / reconnect speed threshold change via Forscan?

[The Bronze]

Anybody have any success at finding the stabilizer bar disconnect/reconnect speed so it can get raised up a little bit? BLM/Forest service road speed limits are routinely 25mph. I would like to get it to stay disconnected to that. The disconnect makes rougher trails SOOO much better by reducing the side to side motion. My interface arrives tomorrow and am looking forward to doing some digging for it.

Sponsored

 

[smahones]

At the Moab Off Roadeo they stated it would reconnect at 20 mph

 

[The Bronze]

At the Moab Off Roadeo they stated it would reconnect at 20 mph

That could probably have been me that told you that..... On some of those longer stretches where we reach 25 mph, it would be nice if the bar stayed disconnected to reduce some of that side to side bounce that occurs on the rougher sections.

 

[palley6]

Its 100% 20mph. If you find that setting in the modules please share, that would be a fantastic upgrade

 

[robepa]

Agreed, updating the disconnect speed to 25 or 30 would be great. I routinely go over 20 on FS roads.

 

[BigMeatsBronco]

Should be as easy as comparing the as built with a Braptor.

 

[ITLRUN]

Any updates here?

I'd love to be able to disconnect it in 2WD too. Any ideas there?

 

[BigMeatsBronco]

I think the ABS module will need raptorized.

 

[BigMeatsBronco]

I tried the Raptor asbuilt in my FE and it caused a few goat mode to be goofed up...I just didn't have it quite right.

Sponsored