Here are the lights and harness I used.Can you share the link?
The harness worked great. It gives you plugs to attach to the lights. Makes it easy to install, replace, or remove the lights. Wired the relay to the 12 volt outlet. Wired the switch to the rear side light. Was not sure what the load capacity was on the rear side light. Although, the overall new light load is very small. About 2 amps. In this configuration, the load goes through the 12 volt outlet wire.
The lights simply bolt on. I did need to replace the light mounting screws. They are setup to be installed with a through bolt and nut. Replaced with a socket head cap screw. Had to grind the top of the screw to clear the light.
https://www.amazon.com/dp/B08THWXFRJ?psc=1&ref=ppx_yo2ov_dt_b_product_details
https://www.amazon.com/dp/B076C4MXR1?psc=1&ref=ppx_yo2ov_dt_b_product_details
Sponsored