Pine Camp on the Rubicon Trail.
Sponsored
I use mine for my GMRS radio and only have it on when I am using it. I never used the adhesive, because it is essentially not needed. I can easily stretch it out enough to unhook the side that has the barb on it.Thank you so much!! Just curious, have you had to remove it yet? If so is it a pain to remove? Thanks again!
Itβs def on the bucket list for sure!If you haven't seen proper Aurora you really should make the trip to the Arctic circle on early to mid September. When. The thing goes, it goes crazy in every direction. Well defined streaks and flares not just a uniform glow.
I was in the Calgary area a week ago and missed out on tonight's show. Had a few locations in mind if I got lucky but alas...
Do you know the width of your tent?Pine Camp on the Rubicon Trail.
Finally got to see the aurora come south.
Untitled by MJH Creations, on Flickr
Untitled by MJH Creations, on Flickr
Untitled by MJH Creations, on Flickr
I'd have to look up the exact measurements but it's about 46" inside, maybe 50" outside.Itβs def on the bucket list for sure!
Do you know the width of your tent?
I love my boys, but it was the happiest day of my life at that point... especially when they were off my payroll.Today the Bronco is helping us become empty nesters. Happy, but sad day
Hi, my Grimm/ARB setup is being installed today. Shop called and said the hood wonβt close because my aftermarket hood struts are in the way. Do you happen to use hood struts? I canβt tell from pic. If so, which brand?Installed an ARB twin compressor in the engine compartment using the Grimm Offroad bracket kit.
Great use of available space and a lot less intrusive than the Ford bracket kit.
Glad to see the Bronco could be a part of this special moment!Today the Bronco is helping us become empty nesters. Happy, but sad day
I have the same compressor and struts from Redline Tuning and all fits fineHi, my Grimm/ARB setup is being installed today. Shop called and said the hood wonβt close because my aftermarket hood struts are in the way. Do you happen to use hood struts? I canβt tell from pic. If so, which brand?
Iβve got the Redline high lift struts that mount rearward of the compressorHi, my Grimm/ARB setup is being installed today. Shop called and said the hood wonβt close because my aftermarket hood struts are in the way. Do you happen to use hood struts? I canβt tell from pic. If so, which brand?
I have the Mabett. Looks like Iβll be replacing them with the Redline. Thank you both for the repliesIβve got the Redline high lift struts that mount rearward of the compressor
No clearance issues