Been there, done that. Telescoping magnet did the trick.
Sponsored
Make sure you install the hood attachment in the right hole.Ok, I hope that my struts are defective and I am not an idiot, but I followed the instructions for mounting the hardware but when I went to attach the struts, they are too long by about 3 inches and will not compress, at all, thus they don't fit. What am I missing here?
Yeah the guy below this has it…took me a minute to figure it out too..lift hood higher then attachOk, I hope that my struts are defective and I am not an idiot, but I followed the instructions for mounting the hardware but when I went to attach the struts, they are too long by about 3 inches and will not compress, at all, thus they don't fit. What am I missing here?
Wrong. Ford performance brand is the only one that adds hp. I put mine on the dyno. Make sure the branding is facing out too.These look identical to the Redline Tuning struts. I got the Redlines and pulled the stickers off. Look factory. I would buy whichever is cheaper and not spend any extra money for a brand.
Not just hood struts. FORD PERFORMANCE hood struts. Total cost over $100 dollars.Jesus. HOOD STRUTS.
Not only that but it was all more money than an off brandI'm out.
Same here but was getting the same non fitment warning. Says they fit all from 2021-2023 except Raptor and Everglades.So, I just ordered -- Free Using Pass Ppints!