Sponsored

Recent content by cbrownabq

  1. Anyone else get better gas mileage after engine mods?

    I have the Ford tune, air filter (waiting on my injen intake) and AFE high tuck exhaust on 37s. Getting 20 mpg.
  2. Braptorizing 2 door Bronco... First Edition Warthog...

    This build is badass. This is like old Pirate4x4 shit. Im so jealous.
  3. Popping, clunking when stopping

    Any progress with this?
  4. MPG - Why so bad?

    I have a 2.7 on 37s. Average 20 mpg city, highway. Can get 21 of I really try. Ford tune with 91 octane. Denver area.
  5. Looking for opinions Pedal Commander or Procal tune or ?

    Both are great products. You will get more out the Pro cal though.
  6. Popping, clunking when stopping

    I have the same issue but, I'm lifted 2 inches with an Antirock sway bar. Ive been trying to hunt it down. I think mine may be lower control arm bushings. The good news is that I found some nuts and bolts that needed retightened. But it still clunks.
  7. The cheap Base Bronco build on 37's

    I love this. I could have saved a fortune
  8. Trail Thrills Thursday! Show Us Your Trail Photos

    Red Cone on a Monday. No one else on the trail.
  9. Underwhelming Offroad experience

    100% True. Ive had built jeeps and now have 37s with no sway bar. IFS just can’t hang. That being said, my Bronco goes where I want it to and drives great!
  10. Steering wheel very sensitive after off-roading

    BDS alignment locks are the bomb for this. No more alignment woes.
  11. Post your 2.7L Bronco Ford Performance Calibration Tune review

    Hey, I had tk get mine to install my Ford Severe Dury Steering stuff. I love the tuner. As stated better shift points and I legit am getting 21 mph on 37s. Great power.
  12. Driver door won’t lock

    No solution yet. Went to the dealer to see if I coyld just leave me door. They said no…Can’t get in for a month. Pulled the door panel and everything looked ok. Plug on door frame looks good.
  13. Anyone actually use their RC High Mount winch?

    Used mine once so far. It was an angled pull but not too difficult. Mount worked fine but I do have the LOD frame supports.


Top